On 31/07/2021 01:10, Sam Protsenko wrote:
> On Fri, 30 Jul 2021 at 19:05, Krzysztof Kozlowski
> <krzysztof.kozlowski@xxxxxxxxxxxxx> wrote:
>>
>> On 30/07/2021 16:49, Sam Protsenko wrote:
>>> Add serial driver data for Exynos850 SoC. This driver data is basically
>>> reusing EXYNOS_COMMON_SERIAL_DRV_DATA, which is common for all Exynos
>>> chips, but also enables USI init, which was added in previous commit:
>>> "tty: serial: samsung: Init USI to keep clocks running".
>>>
>>> Signed-off-by: Sam Protsenko <semen.protsenko@xxxxxxxxxx>
>>> ---
>>> drivers/tty/serial/samsung_tty.c | 13 +++++++++++++
>>> 1 file changed, 13 insertions(+)
>>>
>>> diff --git a/drivers/tty/serial/samsung_tty.c b/drivers/tty/serial/samsung_tty.c
>>> index 75ccbb08df4a..d059b516a0f4 100644
>>> --- a/drivers/tty/serial/samsung_tty.c
>>> +++ b/drivers/tty/serial/samsung_tty.c
>>> @@ -2814,11 +2814,19 @@ static struct s3c24xx_serial_drv_data exynos5433_serial_drv_data = {
>>> .fifosize = { 64, 256, 16, 256 },
>>> };
>>>
>>> +static struct s3c24xx_serial_drv_data exynos850_serial_drv_data = {
>>> + EXYNOS_COMMON_SERIAL_DRV_DATA_USI(1),
>>> + .fifosize = { 0, },
>>
>> This does not look correct. You rely on samsung,uart-fifosize property
>> but it is optional.
>>
>
> Good point. I will replace fifosize elements (in patch series v2) with
> this code (the reasoning is below):
>
> .fifosize = { 256, 64, 64, 64 }
>
> TRM mentions that USI block has configurable FIFO of 16/32/64/128/256
> byte. In vendor kernel they are setting default values in dtsi instead
> of driver, that's where fifosize = { 0 } appeared from. And in vendor
> dtsi they set 256 for serial_0 (USI UART instance), 64 for serial_1
> (CMGP0 UART instance) and 64 for serial_2 (CMGP1 UART instance). I
> tested 256 and 64 for serial_0 (which is used for serial console)
>
> As for fifosize array elements count: though it's possible to
> configure up to 7 UARTs in Exynos850 (it has 5 USI blocks and 2 CMGP
> blocks, which can be configured as USIs), in a regular case it's only
> 3 UARTs (1 in USI and 2 in CMGP). This is how it's done in vendor's
> device tree, and I doubt someone is going to need more than 3 serials
> anyway, looks like very specific case for a mobile SoC. But
> CONFIG_SERIAL_SAMSUNG_UARTS_4=y is set by default when using arm64
> defconfig, and I'd like to keep minimal delta for this defconfig for
> now.
>
> Hope you are ok with this?
>
Yes, sounds good.
Best regards,
Krzysztof
