On Tue, Oct 16, 2018 at 03:04:52PM +0200, Krzysztof Kozlowski wrote: > On Mon, 15 Oct 2018 at 17:50, Bartlomiej Zolnierkiewicz > <b.zolnierkie@xxxxxxxxxxx> wrote: > > > > "Samsung PM Suspend debug" feature (controlled by SAMSUNG_PM_DEBUG > > config option) is not working properly (debug messages are not > > displayed after resume) on Exynos platforms because GPIOs restore > > code is not implemented. > > > > Add PLAT_S3C24XX, ARCH_S3C64XX and ARCH_S5PV210 dependencies to > > SAMSUNG_PM_DEBUG config option to hide it on Exynos platforms. > > Then convert Exynos code to not require <plat/pm-common.h> > > header (use pr_debug() directly instead of S3C_PMDBG() macro and > > remove redundant s3c_pm_*() calls). > > > > Signed-off-by: Bartlomiej Zolnierkiewicz <b.zolnierkie@xxxxxxxxxxx> > > --- > > v3: > > - don't move PM to the line below in Kconfig > > > > v2: > > - convert Exynos code to not require <plat/pm-common.h> header > > > > Should by applied on top of "[PATCH] ARM: EXYNOS: remove no longer > > needed s3c_pm_check_*() calls". > > > > arch/arm/mach-exynos/suspend.c | 14 ++++---------- > > arch/arm/plat-samsung/Kconfig | 1 + > > 2 files changed, 5 insertions(+), 10 deletions(-) > > Thanks. This and the other one (removing s3c_pm_check_*()) look OK > although it is too late for another pull so this will wait for next > cycle. Hi, This does not longer apply. Probably because of my changes around eint wakeup mask. Could you rebase? Best regards, Krzysztof
