DECON command mode can use hardware trigger where transmission is triggered automatically, or software trigger - where TE interrupt handler should trigger transmission. DECON will use software trigger if TE interrupt is specified. Signed-off-by: Andrzej Hajda <a.hajda@xxxxxxxxxxx> --- Documentation/devicetree/bindings/display/exynos/exynos5433-decon.txt | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) diff --git a/Documentation/devicetree/bindings/display/exynos/exynos5433-decon.txt b/Documentation/devicetree/bindings/display/exynos/exynos5433-decon.txt index ba6be99..549c538 100644 --- a/Documentation/devicetree/bindings/display/exynos/exynos5433-decon.txt +++ b/Documentation/devicetree/bindings/display/exynos/exynos5433-decon.txt @@ -10,7 +10,8 @@ Required properties: - reg: physical base address and length of the DECON registers set. - interrupt-names: should contain the interrupt names depending on mode of work: video mode: "vsync", - command mode: "lcd_sys". + command mode: "lcd_sys", + command mode with software trigger: "lcd_sys", "te". - interrupts or interrupts-extended: list of interrupt specifiers corresponding to names privided in interrupt-names, as described in interrupt-controller/interrupts.txt -- 2.7.4 -- To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
 |