On 05/05/2016 10:16 PM, Javier Martinez Canillas wrote:
> Hello Krzysztof,
>
> On 05/05/2016 08:34 AM, Krzysztof Kozlowski wrote:
>> On Odroid U3 (Exynos4412-based) board if USB was initialized by
>> bootloader (in U-Boot "usb start" before tftpboot), the HUB (usb3503)
>> and LAN (smsc95xx) after after successful probing were not visible in the
>> system ("lsusb").
>>
>> In such case the devices had to be fully reset before configuring.
>> Reset by GPIO (called RESET_N pin) and by RESET field in STCD register
>> in usb3503 HUB are not sufficient. Instead full reset has to be done by
>> disabling and enabling regulator.
>>
>> Signed-off-by: Krzysztof Kozlowski <k.kozlowski@xxxxxxxxxxx>
>> ---
>
> [snip]
>
>>
>> + lan_pwrseq: pwrseq2 {
>> + compatible = "mmc-pwrseq-simple";
>
> It feels strange to have a "mmc-pwrseq-simple" compatible for a USB power
> sequence provider. As I mentioned in the other patch, I think there should
> either be a DT binding for the USB pwrseq-simple with a "usb-pwrseq-simple"
> compatible that binds to the same pwrseq-simple driver or maybe having a
> generic DT binding for any device with a new "pwrseq-simple" compatible.
>
> Patch looks good to me though, so after having a DT binding and changing
> the compatible string:
>
> Reviewed-by: Javier Martinez Canillas <javier@xxxxxxxxxxxxxxx>
Probably this will change after Rob's feedback. :)
Best regards,
Krzysztof
--
To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
