Hello Krzysztof,
On 05/05/2016 08:34 AM, Krzysztof Kozlowski wrote:
> On Odroid U3 (Exynos4412-based) board if USB was initialized by
> bootloader (in U-Boot "usb start" before tftpboot), the HUB (usb3503)
> and LAN (smsc95xx) after after successful probing were not visible in the
> system ("lsusb").
>
> In such case the devices had to be fully reset before configuring.
> Reset by GPIO (called RESET_N pin) and by RESET field in STCD register
> in usb3503 HUB are not sufficient. Instead full reset has to be done by
> disabling and enabling regulator.
>
> Signed-off-by: Krzysztof Kozlowski <k.kozlowski@xxxxxxxxxxx>
> ---
[snip]
>
> + lan_pwrseq: pwrseq2 {
> + compatible = "mmc-pwrseq-simple";
It feels strange to have a "mmc-pwrseq-simple" compatible for a USB power
sequence provider. As I mentioned in the other patch, I think there should
either be a DT binding for the USB pwrseq-simple with a "usb-pwrseq-simple"
compatible that binds to the same pwrseq-simple driver or maybe having a
generic DT binding for any device with a new "pwrseq-simple" compatible.
Patch looks good to me though, so after having a DT binding and changing
the compatible string:
Reviewed-by: Javier Martinez Canillas <javier@xxxxxxxxxxxxxxx>
Best regards,
--
Javier Martinez Canillas
Open Source Group
Samsung Research America
--
To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
