HI Sergei,
On Wed, Jun 25, 2014 at 4:04 AM, Sergei Shtylyov
<sergei.shtylyov@xxxxxxxxxxxxxxxxxx> wrote:
> Hello.
>
>
> On 06/10/2014 12:22 AM, Julius Werner wrote:
>
>>> diff --git a/drivers/usb/host/xhci.h b/drivers/usb/host/xhci.h
>>> index 9ffecd5..453d89e 100644
>>> --- a/drivers/usb/host/xhci.h
>>> +++ b/drivers/usb/host/xhci.h
>>> @@ -1582,6 +1582,9 @@ struct xhci_hcd {
>>> u32 port_status_u0;
>>> /* Compliance Mode Timer Triggered every 2 seconds */
>>> #define COMP_MODE_RCVRY_MSECS 2000
>>> + /* phys for the controller */
>>> + struct phy *phy2_gen;
>>> + struct phy *phy3_gen;
>>> };
>
>
>> I don't think adding new variables here and restricting most of this
>> logic to xhci-plat.c (in the next patch) is the best way to do it.
>
>
> Indeed.
>
>
>> There's no conceptual reason why other host controllers (e.g. xhci-pci
>> or even EHCI) could not have a similar need to tune their PHY after
>> reset. PHYs are universal to all host controllers.
>
>
>> There is already a 'phy' member in struct usb_hcd which I think is
>> mostly unused right now. I think it would be much less
>> confusing/redundant to reuse that member for this purpose (you could
>> still set it up from xhci_plat_probe(), and then call it from
>> hcd_bus_resume() or something like that).
>
>
> That member has type 'struct usb_phy *' while here we have 'struct phy *'
> -- feel the difference.
> I have already tried adding 'struct phy *gen_phy' to 'struct usb_hcd',
> however Greg wasn't eager to pick that up so far. Here's the last posting of
> my patch:
>
> http://marc.info/?l=linux-usb&m=140145917506582
Thanks for pointing to the patch, i have also been tracking this patch.
I will try to rework using this patch and post the relevant patches.
--
Best Regards
Vivek Gautam
Samsung R&D Institute, Bangalore
India
--
To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
