Am Samstag, 9. März 2019, 16:39:22 CET schrieb David Summers: > This patch adds wifi support to the ASUS Tinker Board (S) machines. > > This is provided by an wifi card (RTL8723BS) wired into the sdio interface. > > It requires certain pins pulled, to enable the WiFi. > > The schematics for these board do not show the WiFi connection, so the > connections have been taken from: > > https://github.com/TinkerBoard/debian_kernel/blob/develop/arch/arm/boot/dts/rk3288-miniarm.dts > > In particular the pulling of two pins. > > This patch is almost identical to v1. A few additional line breaks for > readability. On Armbian, they did not use sd-uhs-ddr50, so this has > been removed. It does not change functionality. The ASUS patch set > sd-uhs-sdr104;. > > Signed-off-by: David Summers <beagleboard@xxxxxxxxxxxxxxxxxxx> > Signed-off-by: Stefan Wahren <stefan.wahren@xxxxxxxx> trying to understand the relationship here, is that a "Co-developed-by: Stefan Wahren <...>" case? Because individual Signed-off-bys would be (1) author, (2) sender and (3) me and Stefan obviously didn't send the patch :-) > Tested-by: Tony McKahan <tonymckahan@xxxxxxxxx> > Reviewed-by: Robin Murphy <robin.murphy@xxxxxxx> > Test-by: TheSaint @ ArchLinux ARM Same comment about Tested-by with an actual name+mail please. Other than that bit of bureaucracy this looks good, minus some reordering. If you need to resend for whatever reason, please try to order devicetree nodes and properties alphabetical if they don't have an address in the name (otherwise obviously by address). But I can do that reordering myself and also drop the Review-tag naming Robin above, if you clear up the "paperwork" above :-). Heiko Heiko > > --- > arch/arm/boot/dts/rk3288-tinker.dtsi | 40 +++++++++++++++++++++++++++- > 1 file changed, 39 insertions(+), 1 deletion(-) > > diff --git a/arch/arm/boot/dts/rk3288-tinker.dtsi b/arch/arm/boot/dts/rk3288-tinker.dtsi > index ef653c3209bc..0ffab1b7c940 100644 > --- a/arch/arm/boot/dts/rk3288-tinker.dtsi > +++ b/arch/arm/boot/dts/rk3288-tinker.dtsi > @@ -5,6 +5,7 @@ > > #include "rk3288.dtsi" > #include <dt-bindings/input/input.h> > +#include <dt-bindings/clock/rockchip,rk808.h> > > / { > chosen { > @@ -96,6 +97,17 @@ > startup-delay-us = <100000>; > vin-supply = <&vcc_io>; > }; > + > + sdio_pwrseq: sdio-pwrseq { > + compatible = "mmc-pwrseq-simple"; > + clocks = <&rk808 RK808_CLKOUT1>; > + clock-names = "ext_clock"; > + pinctrl-names = "default"; > + pinctrl-0 = <&wifi_enable>; > + reset-gpios = <&gpio4 RK_PD3 GPIO_ACTIVE_LOW>, > + <&gpio4 RK_PD4 GPIO_ACTIVE_LOW>; > + }; > + > }; > > &cpu0 { > @@ -336,7 +348,7 @@ > > &io_domains { > status = "okay"; > - > + wifi-supply = <&vcc_18>; > sdcard-supply = <&vccio_sd>; > }; > > @@ -416,6 +428,13 @@ > rockchip,pins = <7 8 RK_FUNC_GPIO &pcfg_pull_none>; > }; > }; > + > + sdio { > + wifi_enable: wifi-enable { > + rockchip,pins = <4 RK_PD3 RK_FUNC_GPIO &pcfg_pull_none>, > + <4 RK_PD4 RK_FUNC_GPIO &pcfg_pull_none>; > + }; > + }; > }; > > &pwm0 { > @@ -440,6 +459,25 @@ > vqmmc-supply = <&vccio_sd>; > }; > > +&sdio0 { > + bus-width = <4>; > + cap-sd-highspeed; > + cap-sdio-irq; > + keep-power-in-suspend; > + mmc-pwrseq = <&sdio_pwrseq>; > + non-removable; > + pinctrl-names = "default"; > + pinctrl-0 = <&sdio0_bus4>, <&sdio0_cmd>, <&sdio0_clk>, <&sdio0_int>; > + max-frequency = <50000000>; > + sd-uhs-sdr12; > + sd-uhs-sdr25; > + sd-uhs-sdr50; > + vmmc-supply = <&vcc_io>; > + vqmmc-supply = <&vcc_18>; > + status = "okay"; > +}; > + > + > &tsadc { > rockchip,hw-tshut-mode = <1>; /* tshut mode 0:CRU 1:GPIO */ > rockchip,hw-tshut-polarity = <1>; /* tshut polarity 0:LOW 1:HIGH */ > _______________________________________________ Linux-rockchip mailing list Linux-rockchip@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/linux-rockchip
