This patch adds wifi support to the ASUS Tinker Board (S) machines. This is provided by an wifi card (RTL8723BS) wired into the sdio interface. It requires certain pins pulled, to enable the WiFi. The schematics for these board do not show the WiFi connection, so the connections have been taken from: https://github.com/TinkerBoard/debian_kernel/blob/develop/arch/arm/boot/dts/rk3288-miniarm.dts In particular the pulling of two pins. This patch is almost identical to v1. A few additional line breaks for readability. On Armbian, they did not use sd-uhs-ddr50, so this has been removed. It does not change functionality. The ASUS patch set sd-uhs-sdr104;. Signed-off-by: David Summers <beagleboard@xxxxxxxxxxxxxxxxxxx> Signed-off-by: Stefan Wahren <stefan.wahren@xxxxxxxx> Tested-by: Tony McKahan <tonymckahan@xxxxxxxxx> Reviewed-by: Robin Murphy <robin.murphy@xxxxxxx> Test-by: TheSaint @ ArchLinux ARM --- arch/arm/boot/dts/rk3288-tinker.dtsi | 40 +++++++++++++++++++++++++++- 1 file changed, 39 insertions(+), 1 deletion(-) diff --git a/arch/arm/boot/dts/rk3288-tinker.dtsi b/arch/arm/boot/dts/rk3288-tinker.dtsi index ef653c3209bc..0ffab1b7c940 100644 --- a/arch/arm/boot/dts/rk3288-tinker.dtsi +++ b/arch/arm/boot/dts/rk3288-tinker.dtsi @@ -5,6 +5,7 @@ #include "rk3288.dtsi" #include <dt-bindings/input/input.h> +#include <dt-bindings/clock/rockchip,rk808.h> / { chosen { @@ -96,6 +97,17 @@ startup-delay-us = <100000>; vin-supply = <&vcc_io>; }; + + sdio_pwrseq: sdio-pwrseq { + compatible = "mmc-pwrseq-simple"; + clocks = <&rk808 RK808_CLKOUT1>; + clock-names = "ext_clock"; + pinctrl-names = "default"; + pinctrl-0 = <&wifi_enable>; + reset-gpios = <&gpio4 RK_PD3 GPIO_ACTIVE_LOW>, + <&gpio4 RK_PD4 GPIO_ACTIVE_LOW>; + }; + }; &cpu0 { @@ -336,7 +348,7 @@ &io_domains { status = "okay"; - + wifi-supply = <&vcc_18>; sdcard-supply = <&vccio_sd>; }; @@ -416,6 +428,13 @@ rockchip,pins = <7 8 RK_FUNC_GPIO &pcfg_pull_none>; }; }; + + sdio { + wifi_enable: wifi-enable { + rockchip,pins = <4 RK_PD3 RK_FUNC_GPIO &pcfg_pull_none>, + <4 RK_PD4 RK_FUNC_GPIO &pcfg_pull_none>; + }; + }; }; &pwm0 { @@ -440,6 +459,25 @@ vqmmc-supply = <&vccio_sd>; }; +&sdio0 { + bus-width = <4>; + cap-sd-highspeed; + cap-sdio-irq; + keep-power-in-suspend; + mmc-pwrseq = <&sdio_pwrseq>; + non-removable; + pinctrl-names = "default"; + pinctrl-0 = <&sdio0_bus4>, <&sdio0_cmd>, <&sdio0_clk>, <&sdio0_int>; + max-frequency = <50000000>; + sd-uhs-sdr12; + sd-uhs-sdr25; + sd-uhs-sdr50; + vmmc-supply = <&vcc_io>; + vqmmc-supply = <&vcc_18>; + status = "okay"; +}; + + &tsadc { rockchip,hw-tshut-mode = <1>; /* tshut mode 0:CRU 1:GPIO */ rockchip,hw-tshut-polarity = <1>; /* tshut polarity 0:LOW 1:HIGH */ -- beagleboard@xxxxxxxxxxxxxxxxxxx _______________________________________________ Linux-rockchip mailing list Linux-rockchip@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/linux-rockchip
