On 1/5/24 11:23 AM, Claudiu wrote: > From: Claudiu Beznea <claudiu.beznea.uj@xxxxxxxxxxxxxx> > > As some IP variants switch to reset mode (and thus registers content is > lost) when setting clocks (due to module standby functionality) to be able > to implement runtime PM and save more power, set the IP's operating mode to > reset at the end of the probe. Along with it, in the ndo_open API the IP > will be switched to configuration, then operation mode. In the ndo_close > API, the IP will be switched back to reset mode. This allows implementing > runtime PM and, along with it, save more power when the IP is not used. > > Signed-off-by: Claudiu Beznea <claudiu.beznea.uj@xxxxxxxxxxxxxx> > --- > > Changes in v3: > - fixed typos in patch description > - in ravb_probe() switch the hardware to reset mode just after phy > initialization > > Changes in v2: > - none; this patch is new > > > drivers/net/ethernet/renesas/ravb_main.c | 78 ++++++++++++++---------- > 1 file changed, 46 insertions(+), 32 deletions(-) > > diff --git a/drivers/net/ethernet/renesas/ravb_main.c b/drivers/net/ethernet/renesas/ravb_main.c > index 1cc1ecd8d6a8..434b4777de5e 100644 > --- a/drivers/net/ethernet/renesas/ravb_main.c > +++ b/drivers/net/ethernet/renesas/ravb_main.c [...] > @@ -2746,11 +2755,6 @@ static int ravb_probe(struct platform_device *pdev) > ndev->netdev_ops = &ravb_netdev_ops; > ndev->ethtool_ops = &ravb_ethtool_ops; > > - /* Set AVB config mode */ > - error = ravb_set_config_mode(ndev); > - if (error) > - goto out_rpm_put; > - > error = ravb_compute_gti(ndev); > if (error) > goto out_rpm_put; > @@ -2785,13 +2789,23 @@ static int ravb_probe(struct platform_device *pdev) > eth_hw_addr_random(ndev); > } > > + /* Set config mode as this is needed for PHY initialization. */ > + error = ravb_set_opmode(ndev, CCC_OPC_CONFIG); Hm... don't you need this at laest before calling ravb_read_mac_address() just above? > + if (error) > + goto out_rpm_put; > + > /* MDIO bus init */ > error = ravb_mdio_init(priv); > if (error) { > dev_err(&pdev->dev, "failed to initialize MDIO\n"); > - goto out_dma_free; > + goto out_reset_mode; > } > > + /* Undo previous switch to config opmode. */ > + error = ravb_set_opmode(ndev, CCC_OPC_RESET); > + if (error) > + goto out_mdio_release; > + > netif_napi_add(ndev, &priv->napi[RAVB_BE], ravb_poll); > if (info->nc_queues) > netif_napi_add(ndev, &priv->napi[RAVB_NC], ravb_poll); [...] MBR, Sergey