From: Claudiu Beznea <claudiu.beznea.uj@xxxxxxxxxxxxxx>
Hi,
This patch series adds initial support for The Renesas RZ/G3S (R9A08G045{S33})
SoC. The RZ/G3S device is a general-purpose microprocessor with a
single-core Arm® Cortex®-A55 (1.1GHz) and a dual-core Arm® Cortex®-M33 (250MHz),
perfect for an IOT gateway controller.
This includes:
- SoC identification;
- clocks (core clocks, pin controller clock, serial interface, SD ch0
clock) and corresponding resets;
- minimal device tree for SoM and carrier boards.
With this series Linux can boot from eMMC or SD card. The eMMC and uSD
interface are multiplexed on the SoM; selection is made using a hardware
switch.
Patches are gouped as follows:
- 01 documents scif support;
- 02-05 contain fixes on clock drivers identified while adding RZ/G3S
support
- 06 clock cleanups identifies while adding support for RZ/G3S
- 07-13 clock changes needed by RZ/G3S
- 14-21 pinctrl changes needed by RZ/G3S
- 22-28 device tree support for RZ/G3S
Changes in v2:
- addressed review comments
- collected tags
- removed from series patches that were already integrated
- added patches:
- [PATCH v2 19/28] dt-bindings: pinctrl: renesas: set additionalProperties: false
- [PATCH v2 23/28] dt-bindings: arm: renesas: document RZ/G3S SMARC SoM
- [PATCH v2 26/28] dt-bindings: arm: renesas: document SMARC Carrier-II EVK
- please see individual patches for detailed changes
Claudiu Beznea (28):
dt-bindings: serial: renesas,scif: document r9a08g045 support
clk: renesas: rzg2l: wait for status bit of SD mux before continuing
clk: renesas: rzg2l: lock around writes to mux register
clk: renesas: rzg2l: trust value returned by hardware
clk: renesas: rzg2l: fix computation formula
clk: renesas: rzg2l: remove critical area
clk: renesas: rzg2l: add support for RZ/G3S PLL
clk: renesas: rzg2l: add struct clk_hw_data
clk: renesas: rzg2l: remove CPG_SDHI_DSEL from generic header
clk: renesas: rzg2l: refactor sd mux driver
clk: renesas: rzg2l: add a divider clock for RZ/G3S
dt-bindings: clock: renesas,rzg2l-cpg: document RZ/G3S SoC
clk: renesas: add minimal boot support for RZ/G3S SoC
pinctrl: renesas: rzg2l: index all registers based on port offset
pinctrl: renesas: rzg2l: adapt for different SD/PWPR register offsets
pinctrl: renesas: rzg2l: adapt function number for RZ/G3S
pinctrl: renesas: rzg2l: move ds and oi to SoC specific configuration
pinctrl: renesas: rzg2l: add support for different ds values on
different groups
dt-bindings: pinctrl: renesas: set additionalProperties: false
dt-bindings: pinctrl: renesas: document RZ/G3S SoC
pinctrl: renesas: rzg2l: add support for RZ/G3S SoC
arm64: dts: renesas: add initial DTSI for RZ/G3S SoC
dt-bindings: arm: renesas: document RZ/G3S SMARC SoM
arm64: dts: renesas: rzg3l-smarc-som: add initial support for RZ/G3S
SMARC SoM
arm64: dts: renesas: rzg3s-smarc: add initial device tree for RZ SMARC
Carrier-II Board
dt-bindings: arm: renesas: document SMARC Carrier-II EVK
arm64: dts: renesas: r9a08g045s33-smarc: add initial device tree for
RZ/G3S SMARC EVK board
arm64: defconfig: enable RZ/G3S (R9A08G045) SoC
.../bindings/clock/renesas,rzg2l-cpg.yaml | 1 +
.../pinctrl/renesas,rzg2l-pinctrl.yaml | 23 +-
.../bindings/serial/renesas,scif.yaml | 1 +
.../bindings/soc/renesas/renesas.yaml | 13 +
arch/arm64/boot/dts/renesas/Makefile | 2 +
arch/arm64/boot/dts/renesas/r9a08g045.dtsi | 139 ++++
.../boot/dts/renesas/r9a08g045s33-smarc.dts | 17 +
arch/arm64/boot/dts/renesas/r9a08g045s33.dtsi | 14 +
.../boot/dts/renesas/rzg3s-smarc-som.dtsi | 142 ++++
arch/arm64/boot/dts/renesas/rzg3s-smarc.dtsi | 28 +
arch/arm64/configs/defconfig | 1 +
drivers/clk/renesas/Kconfig | 7 +-
drivers/clk/renesas/Makefile | 1 +
drivers/clk/renesas/r9a07g043-cpg.c | 19 +-
drivers/clk/renesas/r9a07g044-cpg.c | 19 +-
drivers/clk/renesas/r9a08g045-cpg.c | 213 ++++++
drivers/clk/renesas/rzg2l-cpg.c | 478 ++++++++++--
drivers/clk/renesas/rzg2l-cpg.h | 33 +-
drivers/pinctrl/renesas/pinctrl-rzg2l.c | 705 ++++++++++++++----
include/dt-bindings/clock/r9a08g045-cpg.h | 242 ++++++
20 files changed, 1860 insertions(+), 238 deletions(-)
create mode 100644 arch/arm64/boot/dts/renesas/r9a08g045.dtsi
create mode 100644 arch/arm64/boot/dts/renesas/r9a08g045s33-smarc.dts
create mode 100644 arch/arm64/boot/dts/renesas/r9a08g045s33.dtsi
create mode 100644 arch/arm64/boot/dts/renesas/rzg3s-smarc-som.dtsi
create mode 100644 arch/arm64/boot/dts/renesas/rzg3s-smarc.dtsi
create mode 100644 drivers/clk/renesas/r9a08g045-cpg.c
create mode 100644 include/dt-bindings/clock/r9a08g045-cpg.h
--
2.39.2
