Re: [PATCH V6] PCI: rcar: Add L1 link state fix into data abort hook

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 7/19/21 10:59 AM, Lorenzo Pieralisi wrote:
[+Pali]

On Sat, Jul 17, 2021 at 12:33:34PM -0500, Bjorn Helgaas wrote:
On Fri, May 14, 2021 at 10:05:49PM +0200, marek.vasut@xxxxxxxxx wrote:
From: Marek Vasut <marek.vasut+renesas@xxxxxxxxx>

The R-Car PCIe controller is capable of handling L0s/L1 link states.
While the controller can enter and exit L0s link state, and exit L1
link state, without any additional action from the driver, to enter
L1 link state, the driver must complete the link state transition by
issuing additional commands to the controller.

The problem is, this transition is not atomic. The controller sets
PMEL1RX bit in PMSR register upon reception of PM_ENTER_L1 DLLP from
the PCIe card, but then the controller enters some sort of inbetween
state. The driver must detect this condition and complete the link
state transition, by setting L1IATN bit in PMCTLR and waiting for
the link state transition to complete.

If a PCIe access happens inside this window, where the controller
is between L0 and L1 link states, the access generates a fault and
the ARM 'imprecise external abort' handler is invoked.

Just like other PCI controller drivers, here we hook the fault handler,
perform the fixup to help the controller enter L1 link state, and then
restart the instruction which triggered the fault. Since the controller
is in L1 link state now, the link can exit from L1 link state to L0 and
successfully complete the access.

While it was suggested to disable L1 link state support completely on
the controller level, this would not prevent the L1 link state entry
initiated by the link partner. This happens e.g. in case a PCIe card
enters D3Hot state, which could be initiated from pci_set_power_state()
if the card indicates D3Hot support, which in turn means link must enter
L1 state. So instead, fix up the L1 link state after all.

Note that this fixup is applicable only to Aarch32 R-Car controllers,
the Aarch64 R-Car perform the same fixup in TFA, see TFA commit [1]
0969397f2 ("rcar_gen3: plat: Prevent PCIe hang during L1X config access")
[1] https://github.com/ARM-software/arm-trusted-firmware/commit/0969397f295621aa26b3d14b76dd397d22be58bf

This patch is horribly ugly but it's working around a horrible
hardware problem, and I don't have any better suggestions, so I guess
we don't really have much choice.

Pali is doing some work on the matter (in particular [1] above) and I
was following that up to see if there was any outcome before merging
this code, I could not follow up myself for lack of time.

arm32 r-car does NOT use atf, so this does not apply here.



[Index of Archives]     [Linux Samsung SOC]     [Linux Wireless]     [Linux Kernel]     [ATH6KL]     [Linux Bluetooth]     [Linux Netdev]     [Kernel Newbies]     [IDE]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux ATA RAID]     [Samba]     [Device Mapper]

  Powered by Linux