Hi Adam,
On Tue, Jul 14, 2020 at 2:34 PM Adam Ford <aford173@xxxxxxxxx> wrote:
> Beacon EmebeddedWorks, formerly Logic PD is introducing a new
> SOM and development kit based on the RZ/G2M SoC from Renesas.
>
> The SOM supports eMMC, WiFi and Bluetooth, along with a Cat-M1
> cellular radio.
>
> The Baseboard has Ethernet, USB, HDMI, stereo audio in and out,
> along with a variety of push buttons and LED's, and support for
> a parallel RGB and an LVDS display.
>
> Signed-off-by: Adam Ford <aford173@xxxxxxxxx>
> ---
> V2: Add support for RGB display, second backlight, fix clock references,
> fix Makefile, remove unsupported versaclock features, and fix typos.
Thanks for the update!
Looks mostly OK to me, "make dtbs_check" found a few issues, though.
> --- a/arch/arm64/boot/dts/renesas/Makefile
> +++ b/arch/arm64/boot/dts/renesas/Makefile
> @@ -5,6 +5,7 @@ dtb-$(CONFIG_ARCH_R8A774A1) += r8a774a1-hihope-rzg2m-ex-idk-1110wr.dtb
> dtb-$(CONFIG_ARCH_R8A774A1) += r8a774a1-hihope-rzg2m-rev2.dtb
> dtb-$(CONFIG_ARCH_R8A774A1) += r8a774a1-hihope-rzg2m-rev2-ex.dtb
> dtb-$(CONFIG_ARCH_R8A774A1) += r8a774a1-hihope-rzg2m-rev2-ex-idk-1110wr.dtb
> +dtb-$(CONFIG_ARCH_R8A774A1) += r8a774a1-beacon-rzg2m-kit.dtb
Please preserve alphabetical sort order.
>
> dtb-$(CONFIG_ARCH_R8A774B1) += r8a774b1-hihope-rzg2n.dtb
> dtb-$(CONFIG_ARCH_R8A774B1) += r8a774b1-hihope-rzg2n-ex.dtb
> --- /dev/null
> +++ b/arch/arm64/boot/dts/renesas/beacon-renesom-baseboard.dtsi
> + lvds {
> + compatible = "panel-lvds";
> + power-supply = <®_lcd_reset>;
> + width-mm = <223>;
> + height-mm = <125>;
> + backlight = <&backlight_lvds>;
> + data-mapping = "vesa-24";
> +
> + panel-timing {
> + /* 800x480@60Hz */
> + clock-frequency = <30000000>;
> + hactive = <800>;
> + vactive = <480>;
> + hsync-len = <48>;
> + hfront-porch = <40>;
> + hback-porch = <40>;
> + vfront-porch = <13>;
> + vback-porch = <29>;
> + vsync-len = <3>;
> + hsync-active = <1>;
> + vsync-active = <3>;
"make dtbs_check
DT_SCHEMA_FILES=Documentation/devicetree/bindings/display/panel/panel-timing.yaml":
lvds: panel-timing:vsync-active:0:0: 3 is not one of [0, 1]
> + de-active = <1>;
> + pixelclk-active = <0>;
> + };
> +
> + port {
> + panel_in: endpoint {
> + remote-endpoint = <&lvds0_out>;
> + };
> + };
> + };
> +
> + rgb {
> + /* Different LCD with compatible timings */
> + compatible = "rocktech,rk070er9427";
> + backlight = <&backlight_rgb>;
> + enable-gpios = <&gpio1 21 GPIO_ACTIVE_HIGH>;
> + port {
> + rgb_panel: endpoint {
> + remote-endpoint = <&du_out_rgb>;
> + };
> + };
Documentation/devicetree/bindings/display/panel/panel-simple.yaml
rgb: 'power-supply' is a required property
> + };
> + versaclock6_bb: versaclock@6a {
As per DT generic node name rules, this should be called
"clock-controller@6a". I'm aware that would cause issues with the
current driver implementation, so I'll accept this for now. But it
would be good to resolve this later.
> + compatible = "idt,5p49v6965";
> + reg = <0x6a>;
> + #clock-cells = <1>;
> + clocks = <&x304_clk>;
> + clock-names = "xin";
> + /* CSI0_MCLK, CSI1_MCLK, AUDIO_CLKIN, USB_HUB_MCLK_BB */
> + assigned-clocks = <&versaclock6_bb 1>,
> + <&versaclock6_bb 2>,
> + <&versaclock6_bb 3>,
> + <&versaclock6_bb 4>;
> + assigned-clock-rates = <24000000>, <24000000>, <24000000>, <24576000>;
> + };
> +};
> + hd3ss3220@47 {
> + compatible = "ti,hd3ss3220";
> + reg = <0x47>;
> + interrupt-parent = <&gpio6>;
> + interrupts = <4 IRQ_TYPE_LEVEL_LOW>;
> +
> + connector {
> + compatible = "usb-c-connector";
> + label = "USB-C";
> + data-role = "dual";
> +
> + ports {
> + #address-cells = <1>;
> + #size-cells = <0>;
> +
> + port@1 {
> + reg = <1>;
> + hd3ss3220_ep: endpoint {
> + remote-endpoint = <&usb3_role_switch>;
> + };
> + };
Documentation/devicetree/bindings/connector/usb-connector.yaml
connector: ports: 'port@0' is a required property
For now, I'd ignore that, as it's a contradiction between the usb-connector
and the hd3ss3220 bindings.
> + };
> + };
> + };
> +};
> index 000000000000..97272f5fa0ab
> --- /dev/null
> +++ b/arch/arm64/boot/dts/renesas/beacon-renesom-som.dtsi
> + versaclock5: versaclock_som@6a {
Same comment: "clock-controller@6a" (ignored for now).
Gr{oetje,eeting}s,
Geert
--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert@xxxxxxxxxxxxxx
In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
-- Linus Torvalds
