From: Geert Uytterhoeven <geert+renesas@xxxxxxxxx>
Add support for input switches SW1-3 on the Renesas RZ/A1 RSK+RZA1
development board.
Note that this uses the IRQ interrupts, as the RZ/A1 GPIO controller
does not include interrupt support.
Signed-off-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxx>
Signed-off-by: Simon Horman <horms+renesas@xxxxxxxxxxxx>
---
arch/arm/boot/dts/r7s72100-rskrza1.dts | 38 ++++++++++++++++++++++++++++++++++
1 file changed, 38 insertions(+)
diff --git a/arch/arm/boot/dts/r7s72100-rskrza1.dts b/arch/arm/boot/dts/r7s72100-rskrza1.dts
index ff24301dc1be..99acfe4fe11a 100644
--- a/arch/arm/boot/dts/r7s72100-rskrza1.dts
+++ b/arch/arm/boot/dts/r7s72100-rskrza1.dts
@@ -8,6 +8,7 @@
/dts-v1/;
#include "r7s72100.dtsi"
#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
#include <dt-bindings/pinctrl/r7s72100-pinctrl.h>
/ {
@@ -28,6 +29,37 @@
reg = <0x08000000 0x02000000>;
};
+ keyboard {
+ compatible = "gpio-keys";
+
+ pinctrl-names = "default";
+ pinctrl-0 = <&keyboard_pins>;
+
+ key-1 {
+ interrupt-parent = <&irqc>;
+ interrupts = <3 IRQ_TYPE_EDGE_BOTH>;
+ linux,code = <KEY_1>;
+ label = "SW1";
+ wakeup-source;
+ };
+
+ key-2 {
+ interrupt-parent = <&irqc>;
+ interrupts = <2 IRQ_TYPE_EDGE_BOTH>;
+ linux,code = <KEY_2>;
+ label = "SW2";
+ wakeup-source;
+ };
+
+ key-3 {
+ interrupt-parent = <&irqc>;
+ interrupts = <5 IRQ_TYPE_EDGE_BOTH>;
+ linux,code = <KEY_3>;
+ label = "SW3";
+ wakeup-source;
+ };
+ };
+
lbsc {
#address-cells = <1>;
#size-cells = <1>;
@@ -101,6 +133,12 @@
<RZA1_PINMUX(1, 7, 1)>; /* RIIC3SDA */
};
+ keyboard_pins: keyboard {
+ pinmux = <RZA1_PINMUX(1, 9, 3)>, /* IRQ3 */
+ <RZA1_PINMUX(1, 8, 3)>, /* IRQ2 */
+ <RZA1_PINMUX(1, 11, 3)>; /* IRQ5 */
+ };
+
/* Serial Console */
scif2_pins: serial2 {
pinmux = <RZA1_PINMUX(3, 0, 6)>, /* TxD2 */
--
2.11.0
