Depending on which video standard is used the driver needs to setup the
hardware to correctly handle fields. If stream is identified as NTSC
or PAL setup field detection and propagate the field detection signal.
Later versions of the datasheet have been updated to make it clear
that FLD register should be set to 0 when dealing with non-interlaced
field formats.
Signed-off-by: Niklas Söderlund <niklas.soderlund+renesas@xxxxxxxxxxxx>
---
drivers/media/platform/rcar-vin/rcar-csi2.c | 15 ++++++++++++---
1 file changed, 12 insertions(+), 3 deletions(-)
---
Hi,
This patch depends on [PATCH v2 0/2] rcar-csi2: Use standby mode instead of resetting
diff --git a/drivers/media/platform/rcar-vin/rcar-csi2.c b/drivers/media/platform/rcar-vin/rcar-csi2.c
index 7a1c9b549e0fffc6..d9b29dbbcc2949de 100644
--- a/drivers/media/platform/rcar-vin/rcar-csi2.c
+++ b/drivers/media/platform/rcar-vin/rcar-csi2.c
@@ -475,7 +475,7 @@ static int rcsi2_calc_mbps(struct rcar_csi2 *priv, unsigned int bpp)
static int rcsi2_start_receiver(struct rcar_csi2 *priv)
{
const struct rcar_csi2_format *format;
- u32 phycnt, vcdt = 0, vcdt2 = 0;
+ u32 phycnt, vcdt = 0, vcdt2 = 0, fld = 0;
unsigned int i;
int mbps, ret;
@@ -507,6 +507,16 @@ static int rcsi2_start_receiver(struct rcar_csi2 *priv)
vcdt2 |= vcdt_part << ((i % 2) * 16);
}
+ if (priv->mf.field != V4L2_FIELD_NONE &&
+ (priv->mf.height == 240 || priv->mf.height == 288)) {
+ fld = FLD_FLD_EN4 | FLD_FLD_EN3 | FLD_FLD_EN2 | FLD_FLD_EN;
+
+ if (priv->mf.height == 240)
+ fld |= FLD_FLD_NUM(2);
+ else
+ fld |= FLD_FLD_NUM(1);
+ }
+
phycnt = PHYCNT_ENABLECLK;
phycnt |= (1 << priv->lanes) - 1;
@@ -519,8 +529,7 @@ static int rcsi2_start_receiver(struct rcar_csi2 *priv)
rcsi2_write(priv, PHTC_REG, 0);
/* Configure */
- rcsi2_write(priv, FLD_REG, FLD_FLD_NUM(2) | FLD_FLD_EN4 |
- FLD_FLD_EN3 | FLD_FLD_EN2 | FLD_FLD_EN);
+ rcsi2_write(priv, FLD_REG, fld);
rcsi2_write(priv, VCDT_REG, vcdt);
if (vcdt2)
rcsi2_write(priv, VCDT2_REG, vcdt2);
--
2.21.0
