Typo: the data line is called "SDA" not "SCA". Signed-off-by: Wolfram Sang <wsa+renesas@xxxxxxxxxxxxxxxxxxxx> --- Documentation/driver-api/gpio/driver.rst | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/Documentation/driver-api/gpio/driver.rst b/Documentation/driver-api/gpio/driver.rst index a92d8837b62b..3043167fc557 100644 --- a/Documentation/driver-api/gpio/driver.rst +++ b/Documentation/driver-api/gpio/driver.rst @@ -135,7 +135,7 @@ This configuration is normally used as a way to achieve one of two things: - inverse wire-OR on an I/O line, for example a GPIO line, making it possible for any driving stage on the line to drive it low even if any other output to the same line is simultaneously driving it high. A special case of this - is driving the SCL and SCA lines of an I2C bus, which is by definition a + is driving the SCL and SDA lines of an I2C bus, which is by definition a wire-OR bus. Both usecases require that the line be equipped with a pull-up resistor. This -- 2.11.0
