Re: [PATCH v2 0/4] I2C0/3/5 pin control for H3 and M3-W

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Uli,

On Fri, Nov 16, 2018 at 8:21 AM Ulrich Hecht <uli+renesas@xxxxxxxx> wrote:
> This is an up-port from the BSP. Unfortunately I could not test these
> because none of those pins seem to be accessible on Salvator boards (not on
> ULCB either, AFAICT), so the best thing I can say is that they don't seem to
> break anything.

I think I replied before...

For Salvator-X(S):
  1. If you set SW5 and SW6 to their center positions, you can access I2C3 on
     EXIO Connector D.
  2. I2C5 is available on test points CP45/46.

> This revision incorporates the suggestions made by Geert; see below for
> details.

Thanks for the update!

Gr{oetje,eeting}s,

                        Geert

-- 
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert@xxxxxxxxxxxxxx

In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
                                -- Linus Torvalds



[Index of Archives]     [Linux Samsung SOC]     [Linux Wireless]     [Linux Kernel]     [ATH6KL]     [Linux Bluetooth]     [Linux Netdev]     [Kernel Newbies]     [IDE]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux ATA RAID]     [Samba]     [Device Mapper]

  Powered by Linux