Hi Simon-san again, > From: Yoshihiro Shimoda, Sent: Wednesday, October 24, 2018 10:05 AM > > Hi Simon-san, > > > From: Simon Horman, Sent: Wednesday, October 17, 2018 5:54 PM > > > > On Tue, Oct 16, 2018 at 03:05:09PM +0900, Yoshihiro Shimoda wrote: > > > This patch adds/enables USB2.0 peripheral for R-Car [DE]3 boards. > > > So, the default mode on each board is: > > > - R-Car D3 Draak board (has a type-A connector) = host. > > > - R-Car E3 Ebisu board (has a type-B micro connector) = peripheral. > > > > > > Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@xxxxxxxxxxx> > > > > Thanks Shimoda-san, > > > > This looks fine to me but I will wait to see if there are other reviews > > before applying. > > > > Reviewed-by: Simon Horman <horms+renesas@xxxxxxxxxxxx> > > Thank you for your review! > However, I'm afraid but, would you wait to apply this patch for a moment? > I realized this board also connects the ID pin to the SoC. So. I'd like to try to use > the pin like other R-Car Gen3 boards. The R-Car E3 Ebisu board can use the ID pin. # Main problem is my using usb connector converter for R-Car E3 doesn't connect the ID pin to the GND. # If I used other usb connector converter, it worked correctly... So, I submitted v3 patch like below: https://patchwork.kernel.org/patch/10654395/ Best regards, Yoshihiro Shimoda
