Re: [PATCH v3 2/8] dt-bindings: media: Document data-enable-active property

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Fri, Jun 01, 2018 at 04:58:27PM +0200, jacopo mondi wrote:
> Hi Sakari,
> 
> On Fri, Jun 01, 2018 at 01:29:10PM +0300, Sakari Ailus wrote:
> > Hi Jacopo,
> >
> > Thanks for the patch.
> >
> > On Tue, May 29, 2018 at 05:05:53PM +0200, Jacopo Mondi wrote:
> > > Add 'data-enable-active' property to endpoint node properties list.
> > >
> > > The property allows to specify the polarity of the data-enable signal, which
> > > when in active state determinates when data lanes have to sampled for valid
> > > pixel data.
> >
> > Lanes or lines? I understand this is forthe parallel interface.
> >
> 
> Now I'm confused. Are the parallel data 'lines' and the CSI-2 one
> 'lanes'? I thought 'lanes' applies to both.. am I wrong?

"Lane" is conventionally refer to a differential pair of wires on a serial
bus such as CSI-2. "Line" is used of a wire on a parallel bus.

-- 
Sakari Ailus
sakari.ailus@xxxxxxxxxxxxxxx



[Index of Archives]     [Linux Samsung SOC]     [Linux Wireless]     [Linux Kernel]     [ATH6KL]     [Linux Bluetooth]     [Linux Netdev]     [Kernel Newbies]     [IDE]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux ATA RAID]     [Samba]     [Device Mapper]

  Powered by Linux