[PATCH v3 2/8] dt-bindings: media: Document data-enable-active property

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Add 'data-enable-active' property to endpoint node properties list.

The property allows to specify the polarity of the data-enable signal, which
when in active state determinates when data lanes have to sampled for valid
pixel data.

Signed-off-by: Jacopo Mondi <jacopo+renesas@xxxxxxxxxx>
---
v3:
- new patch
---
 Documentation/devicetree/bindings/media/video-interfaces.txt | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/Documentation/devicetree/bindings/media/video-interfaces.txt b/Documentation/devicetree/bindings/media/video-interfaces.txt
index 258b8df..9839d26 100644
--- a/Documentation/devicetree/bindings/media/video-interfaces.txt
+++ b/Documentation/devicetree/bindings/media/video-interfaces.txt
@@ -109,6 +109,8 @@ Optional endpoint properties
   Note, that if HSYNC and VSYNC polarities are not specified, embedded
   synchronization may be required, where supported.
 - data-active: similar to HSYNC and VSYNC, specifies data line polarity.
+- data-enable-active: similar to HSYNC and VSYNC, specifies the data enable
+  signal polarity.
 - field-even-active: field signal level during the even field data transmission.
 - pclk-sample: sample data on rising (1) or falling (0) edge of the pixel clock
   signal.
--
2.7.4




[Index of Archives]     [Linux Samsung SOC]     [Linux Wireless]     [Linux Kernel]     [ATH6KL]     [Linux Bluetooth]     [Linux Netdev]     [Kernel Newbies]     [IDE]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux ATA RAID]     [Samba]     [Device Mapper]

  Powered by Linux