HI Andrezej, On Thu, Mar 15, 2018 at 10:44:42AM +0100, Andrzej Hajda wrote: > On 14.03.2018 11:09, jacopo mondi wrote: > > Hi Andrzej, > > thanks for review > > > > On Wed, Mar 14, 2018 at 09:42:36AM +0100, Andrzej Hajda wrote: > >> On 13.03.2018 15:30, Jacopo Mondi wrote: > >>> Add DRM bridge driver for Thine THC63LVD1024 LVDS to digital parallel > >>> output decoder. > >> IMO converter suits here better, but it is just suggestion. > >> > >>> Signed-off-by: Jacopo Mondi <jacopo+renesas@xxxxxxxxxx> > >>> --- > >>> drivers/gpu/drm/bridge/Kconfig | 7 + > >>> drivers/gpu/drm/bridge/Makefile | 1 + > >>> drivers/gpu/drm/bridge/thc63lvd1024.c | 241 ++++++++++++++++++++++++++++++++++ > >>> 3 files changed, 249 insertions(+) > >>> create mode 100644 drivers/gpu/drm/bridge/thc63lvd1024.c > >>> > >>> diff --git a/drivers/gpu/drm/bridge/Kconfig b/drivers/gpu/drm/bridge/Kconfig > >>> index 3b99d5a..facf6bd 100644 > >>> --- a/drivers/gpu/drm/bridge/Kconfig > >>> +++ b/drivers/gpu/drm/bridge/Kconfig > >>> @@ -92,6 +92,13 @@ config DRM_SII9234 > >>> It is an I2C driver, that detects connection of MHL bridge > >>> and starts encapsulation of HDMI signal. > >>> > >>> +config DRM_THINE_THC63LVD1024 > >>> + tristate "Thine THC63LVD1024 LVDS decoder bridge" > >>> + depends on OF > >>> + select DRM_PANEL_BRIDGE > >> You don't use PANEL_BRIDGE, it should be possible to drop the select. > >> > > Ack > > > >>> + ---help--- > >>> + Thine THC63LVD1024 LVDS decoder bridge driver. > >> Decoder to what? > >> Maybe it would be better to say it is LVDS/parallel or LVDS/RGB > >> converter or bridge. > > "LVDS to digital CMOS/TTL parallel data converter" as the manual > > describes the chip? > > Should work, unless we want some consistency in interface names, we have > already: parallel / DPI / RGB. I am little bit confused about relations > between them so I do not want to enforce any. config DRM_THINE_THC63LVD1024 tristate "Thine THC63LVD1024 LVDS decoder bridge" depends on OF ---help--- Thine THC63LVD1024 LVDS/parallel converter driver. I guess this is consistent with other symbol descriptions I found > [snip] > > >>> + > >>> +static int thc63_gpio_init(struct thc63_dev *thc63) > >>> +{ > >>> + thc63->pwdn = devm_gpiod_get_optional(thc63->dev, "pwdn", > >>> + GPIOD_OUT_LOW); > >> Shouldn't be GPIOD_OUT_HIGH - bridge initially disabled? > > No, the PWDN gpio is active low, it puts the chip in power down mode > > when the physical line level is set to 0. > > > > That's another confusing thing, when requesting the GPIO, the actual > > physical line value has to be provided, while when "set_value()" the > > logical one is requested, iirc. > > I think it is opposite, only *raw* functions uses physical level. Other > uses logical level. > > > > > Being the GPIO defined as active low, in power enable we set it to > > "logical inactive" == "physical 1", while during power disable it has > > to be set to "logical active" == "physical 0" > > > > Not the right place to complain here, but imo that's not consistent. > > Or have I misinterpreted the APIs? I cannot do much test, as in my setup > > the PWDN pin is hardwired to +vcc (through a physical switch, not > > controlled through a GPIO though). > > devm_gpiod_get_optional calls (indirectly) gpiod_configure_flags, which > calls gpiod_direction_output which uses logical levels. I clearly mis-interpreted the APIs. I'll fix and I'm sending v4 out shortly. Thanks j > > Regards > Andrzej > > > > > Thanks > > j > > > >> Regards > >> Andrzej > >>> + if (IS_ERR(thc63->pwdn)) { > >>> + dev_err(thc63->dev, "Unable to get GPIO \"pwdn\"\n"); > >>> + return PTR_ERR(thc63->pwdn); > >>> + } > >>> + > >>> + thc63->oe = devm_gpiod_get_optional(thc63->dev, "oe", GPIOD_OUT_LOW); > >>> + if (IS_ERR(thc63->oe)) { > >>> + dev_err(thc63->dev, "Unable to get GPIO \"oe\"\n"); > >>> + return PTR_ERR(thc63->oe); > >>> + } > >>> + > >>> + return 0; > >>> +} > >>> + > >>> +static int thc63_regulator_init(struct thc63_dev *thc63) > >>> +{ > >>> + struct regulator **reg; > >>> + int i; > >>> + > >>> + reg = &thc63->vccs[0]; > >>> + for (i = 0; i < ARRAY_SIZE(thc63->vccs); i++, reg++) { > >>> + *reg = devm_regulator_get_optional(thc63->dev, > >>> + thc63_reg_names[i]); > >>> + if (IS_ERR(*reg)) { > >>> + if (PTR_ERR(*reg) == -EPROBE_DEFER) > >>> + return -EPROBE_DEFER; > >>> + *reg = NULL; > >>> + } > >>> + } > >>> + > >>> + return 0; > >>> +} > >>> + > >>> +static int thc63_probe(struct platform_device *pdev) > >>> +{ > >>> + struct thc63_dev *thc63; > >>> + int ret; > >>> + > >>> + thc63 = devm_kzalloc(&pdev->dev, sizeof(*thc63), GFP_KERNEL); > >>> + if (!thc63) > >>> + return -ENOMEM; > >>> + > >>> + thc63->dev = &pdev->dev; > >>> + platform_set_drvdata(pdev, thc63); > >>> + > >>> + ret = thc63_regulator_init(thc63); > >>> + if (ret) > >>> + return ret; > >>> + > >>> + ret = thc63_gpio_init(thc63); > >>> + if (ret) > >>> + return ret; > >>> + > >>> + ret = thc63_parse_dt(thc63); > >>> + if (ret) > >>> + return ret; > >>> + > >>> + thc63->bridge.driver_private = thc63; > >>> + thc63->bridge.of_node = pdev->dev.of_node; > >>> + thc63->bridge.funcs = &thc63_bridge_func; > >>> + > >>> + drm_bridge_add(&thc63->bridge); > >>> + > >>> + return 0; > >>> +} > >>> + > >>> +static int thc63_remove(struct platform_device *pdev) > >>> +{ > >>> + struct thc63_dev *thc63 = platform_get_drvdata(pdev); > >>> + > >>> + drm_bridge_remove(&thc63->bridge); > >>> + > >>> + return 0; > >>> +} > >>> + > >>> +#ifdef CONFIG_OF > >>> +static const struct of_device_id thc63_match[] = { > >>> + { .compatible = "thine,thc63lvd1024", }, > >>> + { }, > >>> +}; > >>> +MODULE_DEVICE_TABLE(of, thc63_match); > >>> +#endif > >>> + > >>> +static struct platform_driver thc63_driver = { > >>> + .probe = thc63_probe, > >>> + .remove = thc63_remove, > >>> + .driver = { > >>> + .name = "thc63lvd1024", > >>> + .of_match_table = thc63_match, > >>> + }, > >>> +}; > >>> +module_platform_driver(thc63_driver); > >>> + > >>> +MODULE_AUTHOR("Jacopo Mondi <jacopo@xxxxxxxxxx>"); > >>> +MODULE_DESCRIPTION("Thine THC63LVD1024 LVDS decoder DRM bridge driver"); > >>> +MODULE_LICENSE("GPL v2"); > >> >
Attachment:
signature.asc
Description: PGP signature