On Thu, Oct 19, 2017 at 11:39:45PM +0200, Arnd Bergmann wrote: > On Fri, Sep 29, 2017 at 1:52 PM, Simon Horman > <horms+renesas@xxxxxxxxxxxx> wrote: > > ---------------------------------------------------------------- > > Renesas ARM64 Based SoC DT Updates for v4.15 > > > > * r8a7795 (H3) > > - Use r8a7795-cpg-mssr and r8a7795-sysc bindings > > Hardcoded indicies are replaced with symbols now that they are available > > > > - Drop bogus HDMI node name suffixes > > Laurent Pinchart says: Node names should not use numerical suffixes if > > the nodes can be distinguished by unit-address > > > > - Update PFC node name to pin-controller > > Shimoda-san says the PFC node name is changed "from e6060000.pfc and > > pfc@e6060000 to e6060000.pin-controller and pin-controller@e6060000 > > like other Renesas SoCs." > > > > * r8a7795 (H3) ES1.0 > > - Drop extra zero from XHCI unit address > > This corrects a typo were ee0400000 rather than ee040000 was used > > as the unit address. > > > > * r8a7796 (M3-W) > > - Add FDP1 instance > > Laurent Pinchart says: The r8a7796 has a single FDP1 instance. > > > > * r8a7795 (H3) and r8a7796 (M3-W) SoCs > > - Add USB3.0 peripheral device nodes > > Shimoda-san says that this is not enabled on the Salvator-X/XS boards > > for now as: > > + we need a special cable (USB type-A to A cross cable). > > + we can swap the role by renesas_usb3 driver even if we use a normal > > cable and after usb3.0 host is running, but I think it's a special > > use case. > > > > * r8a7795 (H3) and r8a7796 (M3-W) ULCB boards > > - Enable display output > > Laurent Pinchart says: The DU is already wired up to the HDMI encoder, > > all we need to do is enable it. > > > > * r8a77995 (D3) Draak board > > - Enable EthernetAVB and , USB2.0 Host and PHY > > > > - Add serial console pins. > > This is safe to do now that r8a77995 PFC driver support is present > > > > * r8a77970 (V3M) > > - Add basic support for SoC and EtherAVB, [H]SCIF and SYS-DMAC nodes > > This is a step towards enabling EtherAVB and [H]SCIF with SYS-DMAC > > in the Eagle board support for which is under review > > Thanks for the detailed changelog! > > > ---------------------------------------------------------------- > > Geert Uytterhoeven (6): > > arm64: dts: renesas: r8a7795-es1: Drop extra zero from usb unit address > > arm64: dts: renesas: r8a7795: Drop bogus HDMI node names suffixes > > arm64: renesas: Add Renesas R8A77970 Kconfig support > > That one last commit doesn't seem to belong in here, but I've pulled > it anyway, thanks! Thanks! I take it you would have prefered this in an soc branch?
