On 3/7/2023 7:57 PM, Kathiravan T wrote:
On 3/7/2023 10:11 AM, Manikanta Mylavarapu wrote:Enable nodes required for multipd remoteproc bring up. Signed-off-by: Manikanta Mylavarapu <quic_mmanikan@xxxxxxxxxxx> --- arch/arm64/boot/dts/qcom/ipq9574.dtsi | 145 ++++++++++++++++++++++++++ 1 file changed, 145 insertions(+)diff --git a/arch/arm64/boot/dts/qcom/ipq9574.dtsi b/arch/arm64/boot/dts/qcom/ipq9574.dtsiindex 2bb4053641da..e0645bc39db4 100644 --- a/arch/arm64/boot/dts/qcom/ipq9574.dtsi +++ b/arch/arm64/boot/dts/qcom/ipq9574.dtsi @@ -201,6 +201,11 @@ tz_region: tz@4a600000 { no-map; }; + q6_region: wcnss@4ab00000 { + reg = <0x0 0x4ab00000 0x0 0x02b00000>;No need to pad the size
Sure, i will do it.
+ no-map; + }; + smem@4aa00000 { compatible = "qcom,smem"; reg = <0x0 0x4aa00000 0x0 0x00100000>; @@ -209,6 +214,30 @@ smem@4aa00000 { }; }; + wcss: wcss-smp2p { + compatible = "qcom,smp2p"; + qcom,smem = <435>, <428>; + + interrupt-parent = <&intc>; + interrupts = <GIC_SPI 322 IRQ_TYPE_EDGE_RISING>; + + mboxes = <&apcs_glb 9>; + + qcom,local-pid = <0>; + qcom,remote-pid = <1>; + + wcss_smp2p_out: master-kernel { + qcom,entry-name = "master-kernel"; + #qcom,smem-state-cells = <1>; + }; + + wcss_smp2p_in: slave-kernel { + qcom,entry-name = "slave-kernel"; + interrupt-controller; + #interrupt-cells = <2>; + }; + }; + soc: soc@0 { compatible = "simple-bus"; #address-cells = <1>; @@ -829,6 +858,122 @@ IRQ_TYPE_LEVEL_HIGH>, /* int_c */ msi-parent = <&v2m0>; status = "disabled"; }; + + q6v5_wcss: remoteproc@cd00000 { + compatible = "qcom,ipq9574-q6-mpd"; + #address-cells = <1>; + #size-cells = <1>; + ranges; + reg = <0x0cd00000 0x4040>;reg should go after compatible
Sure, i will do it.
+ interrupts-extended = <&intc GIC_SPI 325 IRQ_TYPE_EDGE_RISING>,+ <&wcss_smp2p_in 0 0>, + <&wcss_smp2p_in 1 0>, + <&wcss_smp2p_in 2 0>, + <&wcss_smp2p_in 3 0>; + interrupt-names = "wdog", + "fatal", + "ready", + "handover", + "stop-ack"; + + clocks = <&gcc GCC_ANOC_WCSS_AXI_M_CLK>, + <&gcc GCC_WCSS_AHB_S_CLK>, + <&gcc GCC_WCSS_ECAHB_CLK>, + <&gcc GCC_WCSS_ACMT_CLK>, + <&gcc GCC_WCSS_AXI_M_CLK>, + <&gcc GCC_Q6_AXIM_CLK>, + <&gcc GCC_Q6_AXIM2_CLK>, + <&gcc GCC_Q6_AHB_CLK>, + <&gcc GCC_Q6_AHB_S_CLK>, + <&gcc GCC_Q6SS_BOOT_CLK>, + <&gcc GCC_WCSS_DBG_IFC_APB_BDG_CLK>, + <&gcc GCC_WCSS_DBG_IFC_ATB_BDG_CLK>, + <&gcc GCC_WCSS_DBG_IFC_DAPBUS_BDG_CLK>, + <&gcc GCC_WCSS_DBG_IFC_NTS_BDG_CLK>, + <&gcc GCC_WCSS_DBG_IFC_APB_CLK>, + <&gcc GCC_WCSS_DBG_IFC_ATB_CLK>, + <&gcc GCC_WCSS_DBG_IFC_DAPBUS_CLK>, + <&gcc GCC_WCSS_DBG_IFC_NTS_CLK>, + <&gcc GCC_Q6_TSCTR_1TO2_CLK>, + <&gcc GCC_Q6SS_ATBM_CLK>, + <&gcc GCC_Q6SS_PCLKDBG_CLK>, + <&gcc GCC_Q6SS_TRIG_CLK>, + <&gcc GCC_MEM_NOC_Q6_AXI_CLK>, + <&gcc GCC_WCSS_Q6_TBU_CLK>, + <&gcc GCC_SYS_NOC_WCSS_AHB_CLK>; + + clock-names = "anoc_wcss_axi_m", + "wcss_ahb_s", + "wcss_ecahb", + "wcss_acmt", + "wcss_axi_m", + "q6_axim", + "q6_axim2", + "q6_ahb", + "q6_ahb_s", + "q6ss_boot", + "dbg-apb-bdg", + "dbg-atb-bdg", + "dbg-dapbus-bdg", + "dbg-nts-bdg", + "dbg-apb", + "dbg-atb", + "dbg-dapbus", + "dbg-nts", + "q6_tsctr_1to2_clk", + "q6ss_atbm_clk", + "q6ss_pclkdbg_clk", + "q6ss_trig_clk", + "mem_noc_q6_axi", + "wcss_q6_tbu", + "sys_noc_wcss_ahb"; + + assigned-clocks = <&gcc GCC_ANOC_WCSS_AXI_M_CLK>, + <&gcc GCC_WCSS_AHB_S_CLK>,please take care of the alignment
Sure, i will do it.
+ <&gcc GCC_WCSS_ECAHB_CLK>, + <&gcc GCC_WCSS_ACMT_CLK>, + <&gcc GCC_WCSS_AXI_M_CLK>, + <&gcc GCC_Q6_AXIM_CLK>, + <&gcc GCC_Q6_AXIM2_CLK>, + <&gcc GCC_Q6_AHB_CLK>, + <&gcc GCC_Q6_AHB_S_CLK>, + <&gcc GCC_Q6SS_BOOT_CLK>, + <&gcc GCC_MEM_NOC_Q6_AXI_CLK>, + <&gcc GCC_WCSS_Q6_TBU_CLK>, + <&gcc GCC_SYS_NOC_WCSS_AHB_CLK>; + + assigned-clock-rates = <266666667>, + <133333333>,same here
Sure, i will do it. Thanks & Regards, Manikanta.
+ <133333333>, + <133333333>, + <266666667>, + <533000000>, + <342857143>, + <133333333>, + <133333333>, + <342857143>, + <533000000>, + <533000000>, + <133333333>; + + qcom,smem-states = <&wcss_smp2p_out 0>, + <&wcss_smp2p_out 1>; + qcom,smem-state-names = "shutdown", + "stop"; + + memory-region = <&q6_region>; + + glink-edge { + interrupts = <GIC_SPI 321 IRQ_TYPE_EDGE_RISING>; + label = "rtr"; + qcom,remote-pid = <1>; + mboxes = <&apcs_glb 8>; + }; + + q6_wcss_pd1: remoteproc_pd1 { + compatible = "qcom,ipq9574-wcss-ahb-mpd"; + }; + }; }; rpm-glink {
