From: Vladimir Lypak <vladimir.lypak@xxxxxxxxx>
RPM Firmware on variety of newer SoCs such as MSM8917 (also likely
MSM8937, MSM8940, MSM8952), MSM8953 and on some MSM8916 devices) doesn't
initiate opening of the SMD channel if it was previously opened by
bootloader. This doesn't allow probing of smd-rpm driver on such devices
because there is a check that requires RPM this behaviour.
Signed-off-by: Vladimir Lypak <vladimir.lypak@xxxxxxxxx>
Signed-off-by: Luca Weiss <luca@xxxxxxxxx>
Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxxxxxx>
---
drivers/rpmsg/qcom_smd.c | 8 +-------
1 file changed, 1 insertion(+), 7 deletions(-)
diff --git a/drivers/rpmsg/qcom_smd.c b/drivers/rpmsg/qcom_smd.c
index 8da1b5cb31b3..6a01ef932b01 100644
--- a/drivers/rpmsg/qcom_smd.c
+++ b/drivers/rpmsg/qcom_smd.c
@@ -1280,19 +1280,13 @@ static void qcom_channel_state_worker(struct work_struct *work)
unsigned long flags;
/*
- * Register a device for any closed channel where the remote processor
- * is showing interest in opening the channel.
+ * Register a device for any closed channel.
*/
spin_lock_irqsave(&edge->channels_lock, flags);
list_for_each_entry(channel, &edge->channels, list) {
if (channel->state != SMD_CHANNEL_CLOSED)
continue;
- remote_state = GET_RX_CHANNEL_INFO(channel, state);
- if (remote_state != SMD_CHANNEL_OPENING &&
- remote_state != SMD_CHANNEL_OPENED)
- continue;
-
if (channel->registered)
continue;
--
2.34.1
