On Wed, 30 Dec 2020 02:27:21 +0100, Martin Blumenstingl wrote: > The Meson8/Meson8b/Meson8m2 SoCs have a register bank called SECBUS2 which > contains registers for various IP blocks such as pin-controller bits for > the BSD_EN and TEST_N GPIOs as well as some AO ARC core control bits. > The registers can be accessed directly when not running in "secure mode". > When "secure mode" is enabled then these registers have to be accessed > through secure monitor calls. > > So far these SoCs are always known to boot in "non-secure mode". > Add a binding documentation using syscon (as these registers are shared > across different IPs) for the SECBUS2 registers. > > Signed-off-by: Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx> > --- > .../arm/amlogic/amlogic,meson-mx-secbus2.yaml | 53 +++++++++++++++++++ > 1 file changed, 53 insertions(+) > create mode 100644 Documentation/devicetree/bindings/arm/amlogic/amlogic,meson-mx-secbus2.yaml > My bot found errors running 'make dt_binding_check' on your patch: yamllint warnings/errors: ./Documentation/devicetree/bindings/arm/amlogic/amlogic,meson-mx-secbus2.yaml:35:9: [warning] wrong indentation: expected 10 but found 8 (indentation) dtschema/dtc warnings/errors: See https://patchwork.ozlabs.org/patch/1421302 This check can fail if there are any dependencies. The base for a patch series is generally the most recent rc1. If you already ran 'make dt_binding_check' and didn't see the above error(s), then make sure 'yamllint' is installed and dt-schema is up to date: pip3 install dtschema --upgrade Please check and re-submit.
