On Tue, Jan 9, 2024 at 4:41 PM Li Zhijian <lizhijian@xxxxxxxxxxx> wrote:
>
> commit 9ac01f434a1e ("RDMA/rxe: Extend dbg log messages to err and info")
> newly added this info. But it did only show null device when
> the rdma_rxe is being loaded because dev_name(rxe->ib_dev->dev)
> has not yet been assigned at the moment:
>
> "(null): rxe_set_mtu: Set mtu to 1024"
>
> Remove it to silent this message, check the mtu from it backend link
> instead if needed.
>
> CC: Bob Pearson <rpearsonhpe@xxxxxxxxx>
> Signed-off-by: Li Zhijian <lizhijian@xxxxxxxxxxx>
> ---
> V4: Remove it rather than re-order rxe_set_mtu() and rxe_register_device()
> ---
> drivers/infiniband/sw/rxe/rxe.c | 2 --
> 1 file changed, 2 deletions(-)
>
> diff --git a/drivers/infiniband/sw/rxe/rxe.c b/drivers/infiniband/sw/rxe/rxe.c
> index a086d588e159..ae466e72fc43 100644
> --- a/drivers/infiniband/sw/rxe/rxe.c
> +++ b/drivers/infiniband/sw/rxe/rxe.c
> @@ -160,8 +160,6 @@ void rxe_set_mtu(struct rxe_dev *rxe, unsigned int ndev_mtu)
>
> port->attr.active_mtu = mtu;
> port->mtu_cap = ib_mtu_enum_to_int(mtu);
> -
> - rxe_info_dev(rxe, "Set mtu to %d\n", port->mtu_cap);
I'd like to keep this statement so I can tell if the mtu setup was
successful or not.
> }
>
> /* called by ifc layer to create new rxe device.
> --
> 2.29.2
>
>
