On Tuesday 13 January 2009, Alan Stern wrote:
> This patch (as1199) changes the initial wakeup settings for PCI USB
> host controllers. The controllers are marked as capable of waking the
> system, but wakeup is not enabled by default.
>
> It turns out that enabling wakeup for USB host controllers has a lot
> of bad consequences. As the simplest example, if a USB mouse or
> keyboard is unplugged immediately after the computer is put to sleep,
> the unplug will cause the system to wake back up again! We are better
> off marking them as wakeup-capable and leaving wakeup disabled.
>
> Signed-off-by: Alan Stern <stern@xxxxxxxxxxxxxxxxxxx>
> Reported-by: Rafael J. Wysocki <rjw@xxxxxxx>
> CC: David Brownell <david-b@xxxxxxxxxxx>
I have now tested the patch and it helps here as expected, so Greg please
push it to Linus ASAP, because many people have reported the problem it fixes
already.
Acked-by: Rafael J. Wysocki <rjw@xxxxxxx>
Thanks,
Rafael
> ---
>
> This patch should also be queued for 2.6.28.stable.
>
>
> Index: usb-2.6/drivers/usb/core/hcd-pci.c
> ===================================================================
> --- usb-2.6.orig/drivers/usb/core/hcd-pci.c
> +++ usb-2.6/drivers/usb/core/hcd-pci.c
> @@ -128,7 +128,6 @@ int usb_hcd_pci_probe(struct pci_dev *de
> }
>
> pci_set_master(dev);
> - device_set_wakeup_enable(&dev->dev, 1);
>
> retval = usb_add_hcd(hcd, dev->irq, IRQF_DISABLED | IRQF_SHARED);
> if (retval != 0)
> Index: usb-2.6/drivers/usb/host/ehci-pci.c
> ===================================================================
> --- usb-2.6.orig/drivers/usb/host/ehci-pci.c
> +++ usb-2.6/drivers/usb/host/ehci-pci.c
> @@ -230,7 +230,7 @@ static int ehci_pci_setup(struct usb_hcd
> pci_read_config_word(pdev, 0x62, &port_wake);
> if (port_wake & 0x0001) {
> dev_warn(&pdev->dev, "Enabling legacy PCI PM\n");
> - device_init_wakeup(&pdev->dev, 1);
> + device_set_wakeup_capable(&pdev->dev, 1);
> }
> }
>
> Index: usb-2.6/drivers/usb/host/ohci-hcd.c
> ===================================================================
> --- usb-2.6.orig/drivers/usb/host/ohci-hcd.c
> +++ usb-2.6/drivers/usb/host/ohci-hcd.c
> @@ -593,12 +593,10 @@ static int ohci_run (struct ohci_hcd *oh
> * to be checked in case boot firmware (BIOS/SMM/...) has set up
> * wakeup in a way the bus isn't aware of (e.g., legacy PCI PM).
> * If the bus glue detected wakeup capability then it should
> - * already be enabled. Either way, if wakeup should be enabled
> - * but isn't, we'll enable it now.
> + * already be enabled; if so we'll just enable it again.
> */
> - if ((ohci->hc_control & OHCI_CTRL_RWC) != 0
> - && !device_can_wakeup(hcd->self.controller))
> - device_init_wakeup(hcd->self.controller, 1);
> + if ((ohci->hc_control & OHCI_CTRL_RWC) != 0)
> + device_set_wakeup_capable(hcd->self.controller, 1);
>
> switch (ohci->hc_control & OHCI_CTRL_HCFS) {
> case OHCI_USB_OPER:
>
_______________________________________________
linux-pm mailing list
linux-pm@xxxxxxxxxxxxxxxxxxxxxxxxxx
https://lists.linux-foundation.org/mailman/listinfo/linux-pm
