> -----Original Message-----
> From: Lucas Stach <l.stach@xxxxxxxxxxxxxx>
> Sent: 2020年7月21日 16:16
> To: Richard Zhu <hongxing.zhu@xxxxxxx>; bhelgaas@xxxxxxxxxx;
> shawnguo@xxxxxxxxxx; festevam@xxxxxxxxx
> Cc: linux-pci@xxxxxxxxxxxxxxx; dl-linux-imx <linux-imx@xxxxxxx>;
> linux-arm-kernel@xxxxxxxxxxxxxxxxxxx; linux-kernel@xxxxxxxxxxxxxxx;
> kernel@xxxxxxxxxxxxxx
> Subject: [EXT] Re: [PATCH 1/2] ARM: dts: imx6qp-sabresd: enable pcie
> Am Dienstag, den 21.07.2020, 15:44 +0800 schrieb Richard Zhu:
> > Add one regulator, used to power up the external oscillator, and
> > enable PCIe on iMX6QP SABRESD board.
>
> That's not the right thing to do. If there is an external oscillator, which
> requires a power supply then the oscillator should have its own clock DT
> node (it's a separate device after all) and this node needs to control the
> regulator.
>
> This has nothing to do with the PCIe controller, which only cares about the
> clock being provided.
>
Hi Lucas:
Thanks for your comments.
Okay, I would integrate the regulator into one clock node later.
Best Regards
Richard Zhu
> Regards,
> Lucas
>
> > Signed-off-by: Richard Zhu <hongxing.zhu@xxxxxxx>
> > ---
> > arch/arm/boot/dts/imx6qp-sabresd.dts | 3 ++-
> > 1 file changed, 2 insertions(+), 1 deletion(-)
> >
> > diff --git a/arch/arm/boot/dts/imx6qp-sabresd.dts
> > b/arch/arm/boot/dts/imx6qp-sabresd.dts
> > index 480e73183f6b..cd8a1f610427 100644
> > --- a/arch/arm/boot/dts/imx6qp-sabresd.dts
> > +++ b/arch/arm/boot/dts/imx6qp-sabresd.dts
> > @@ -51,7 +51,8 @@
> > };
> >
> > &pcie {
> > - status = "disabled";
> > + vepdev-supply = <&vgen3_reg>;
> > + status = "okay";
> > };
> >
> > &sata {
