Remove unused private PCI definitions from skfbi.h because generic PCI symbols are already included from pci_regs.h. Signed-off-by: Puranjay Mohan <puranjay12@xxxxxxxxx> --- drivers/net/fddi/skfp/h/skfbi.h | 76 --------------------------------- 1 file changed, 76 deletions(-) diff --git a/drivers/net/fddi/skfp/h/skfbi.h b/drivers/net/fddi/skfp/h/skfbi.h index 5f9b631e7515..0b5bd2e170a7 100644 --- a/drivers/net/fddi/skfp/h/skfbi.h +++ b/drivers/net/fddi/skfp/h/skfbi.h @@ -24,49 +24,6 @@ * (ML) = only defined for Monalisa */ -/* - * Configuration Space header - */ -#define PCI_VENDOR_ID 0x00 /* 16 bit Vendor ID */ -#define PCI_DEVICE_ID 0x02 /* 16 bit Device ID */ -#define PCI_COMMAND 0x04 /* 16 bit Command */ -#define PCI_STATUS 0x06 /* 16 bit Status */ -#define PCI_REVISION_ID 0x08 /* 8 bit Revision ID */ -#define PCI_CLASS_CODE 0x09 /* 24 bit Class Code */ -#define PCI_CACHE_LSZ 0x0c /* 8 bit Cache Line Size */ -#define PCI_LAT_TIM 0x0d /* 8 bit Latency Timer */ -#define PCI_HEADER_T 0x0e /* 8 bit Header Type */ -#define PCI_BIST 0x0f /* 8 bit Built-in selftest */ -#define PCI_BASE_1ST 0x10 /* 32 bit 1st Base address */ -#define PCI_BASE_2ND 0x14 /* 32 bit 2nd Base address */ -/* Byte 18..2b: Reserved */ -#define PCI_SUB_VID 0x2c /* 16 bit Subsystem Vendor ID */ -#define PCI_SUB_ID 0x2e /* 16 bit Subsystem ID */ -#define PCI_BASE_ROM 0x30 /* 32 bit Expansion ROM Base Address */ -/* Byte 34..33: Reserved */ -#define PCI_CAP_PTR 0x34 /* 8 bit (ML) Capabilities Ptr */ -/* Byte 35..3b: Reserved */ -#define PCI_IRQ_LINE 0x3c /* 8 bit Interrupt Line */ -#define PCI_IRQ_PIN 0x3d /* 8 bit Interrupt Pin */ -#define PCI_MIN_GNT 0x3e /* 8 bit Min_Gnt */ -#define PCI_MAX_LAT 0x3f /* 8 bit Max_Lat */ -/* Device Dependent Region */ -#define PCI_OUR_REG 0x40 /* 32 bit (DV) Our Register */ -#define PCI_OUR_REG_1 0x40 /* 32 bit (ML) Our Register 1 */ -#define PCI_OUR_REG_2 0x44 /* 32 bit (ML) Our Register 2 */ -/* Power Management Region */ -#define PCI_PM_CAP_ID 0x48 /* 8 bit (ML) Power Management Cap. ID */ -#define PCI_PM_NITEM 0x49 /* 8 bit (ML) Next Item Ptr */ -#define PCI_PM_CAP_REG 0x4a /* 16 bit (ML) Power Management Capabilities */ -#define PCI_PM_CTL_STS 0x4c /* 16 bit (ML) Power Manag. Control/Status */ -/* Byte 0x4e: Reserved */ -#define PCI_PM_DAT_REG 0x4f /* 8 bit (ML) Power Manag. Data Register */ -/* VPD Region */ -#define PCI_VPD_CAP_ID 0x50 /* 8 bit (ML) VPD Cap. ID */ -#define PCI_VPD_NITEM 0x51 /* 8 bit (ML) Next Item Ptr */ -#define PCI_VPD_ADR_REG 0x52 /* 16 bit (ML) VPD Address Register */ -#define PCI_VPD_DAT_REG 0x54 /* 32 bit (ML) VPD Data Register */ -/* Byte 58..ff: Reserved */ /* * I2C Address (PCI Config) @@ -76,39 +33,6 @@ */ #define I2C_ADDR_VPD 0xA0 /* I2C address for the VPD EEPROM */ -/* - * Define Bits and Values of the registers - */ -/* PCI_VENDOR_ID 16 bit Vendor ID */ -/* PCI_DEVICE_ID 16 bit Device ID */ -/* Values for Vendor ID and Device ID shall be patched into the code */ -/* PCI_COMMAND 16 bit Command */ -#define PCI_FBTEN 0x0200 /* Bit 9: Fast Back-To-Back enable */ -#define PCI_SERREN 0x0100 /* Bit 8: SERR enable */ -#define PCI_ADSTEP 0x0080 /* Bit 7: Address Stepping */ -#define PCI_PERREN 0x0040 /* Bit 6: Parity Report Response enable */ -#define PCI_VGA_SNOOP 0x0020 /* Bit 5: VGA palette snoop */ -#define PCI_MWIEN 0x0010 /* Bit 4: Memory write an inv cycl ena */ -#define PCI_SCYCEN 0x0008 /* Bit 3: Special Cycle enable */ -#define PCI_BMEN 0x0004 /* Bit 2: Bus Master enable */ -#define PCI_MEMEN 0x0002 /* Bit 1: Memory Space Access enable */ -#define PCI_IOEN 0x0001 /* Bit 0: IO Space Access enable */ - -/* PCI_STATUS 16 bit Status */ -#define PCI_PERR 0x8000 /* Bit 15: Parity Error */ -#define PCI_SERR 0x4000 /* Bit 14: Signaled SERR */ -#define PCI_RMABORT 0x2000 /* Bit 13: Received Master Abort */ -#define PCI_RTABORT 0x1000 /* Bit 12: Received Target Abort */ -#define PCI_STABORT 0x0800 /* Bit 11: Sent Target Abort */ -#define PCI_DEVSEL 0x0600 /* Bit 10..9: DEVSEL Timing */ -#define PCI_DEV_FAST (0<<9) /* fast */ -#define PCI_DEV_MEDIUM (1<<9) /* medium */ -#define PCI_DEV_SLOW (2<<9) /* slow */ -#define PCI_DATAPERR 0x0100 /* Bit 8: DATA Parity error detected */ -#define PCI_FB2BCAP 0x0080 /* Bit 7: Fast Back-to-Back Capability */ -#define PCI_UDF 0x0040 /* Bit 6: User Defined Features */ -#define PCI_66MHZCAP 0x0020 /* Bit 5: 66 MHz PCI bus clock capable */ -#define PCI_NEWCAP 0x0010 /* Bit 4: New cap. list implemented */ #define PCI_ERRBITS (PCI_STATUS_DETECTED_PARITY | PCI_STATUS_SIG_SYSTEM_ERROR | PCI_STATUS_REC_MASTER_ABORT | PCI_STATUS_SIG_TARGET_ABORT | PCI_STATUS_PARITY) -- 2.21.0
