On 6/6/2019 10:00 PM, Dmitry Osipenko wrote:
26.05.2019 7:37, Vidya Sagar пишет:
Synopsys DesignWare core based PCIe controllers in Tegra 194 SoC interface
with Universal PHY (UPHY) module through a PIPE2UPHY (P2U) module.
For each PCIe lane of a controller, there is a P2U unit instantiated at
hardware level. This driver provides support for the programming required
for each P2U that is going to be used for a PCIe controller.
Signed-off-by: Vidya Sagar <vidyas@xxxxxxxxxx>
---
Changes since [v7]:
* Changed P2U driver file name from pcie-p2u-tegra194.c to phy-tegra194-p2u.c
Changes since [v6]:
* None
Changes since [v5]:
* Addressed review comments from Thierry
Changes since [v4]:
* None
Changes since [v3]:
* Rebased on top of linux-next top of the tree
Changes since [v2]:
* Replaced spaces with tabs in Kconfig file
* Sorted header file inclusion alphabetically
Changes since [v1]:
* Added COMPILE_TEST in Kconfig
* Removed empty phy_ops implementations
* Modified code according to DT documentation file modifications
drivers/phy/tegra/Kconfig | 7 ++
drivers/phy/tegra/Makefile | 1 +
drivers/phy/tegra/phy-tegra194-p2u.c | 109 +++++++++++++++++++++++++++
3 files changed, 117 insertions(+)
create mode 100644 drivers/phy/tegra/phy-tegra194-p2u.c
diff --git a/drivers/phy/tegra/Kconfig b/drivers/phy/tegra/Kconfig
index a3b1de953fb7..c56fc8452e03 100644
--- a/drivers/phy/tegra/Kconfig
+++ b/drivers/phy/tegra/Kconfig
@@ -6,3 +6,10 @@ config PHY_TEGRA_XUSB
To compile this driver as a module, choose M here: the module will
be called phy-tegra-xusb.
+
+config PHY_TEGRA194_P2U
+ tristate "NVIDIA Tegra194 PIPE2UPHY PHY driver"
+ depends on ARCH_TEGRA || COMPILE_TEST
ARCH_TEGRA is a bit too much, ARCH_TEGRA_194_SOC should fit better here.
Ok. I'll take care of it in the next patch series.
