Add MSM8998 PCIe QMP PHY and PCIe root complex DT nodes. Based on the following DTS downstream: https://source.codeaurora.org/quic/la/kernel/msm-4.4/tree/arch/arm/boot/dts/qcom/msm8998.dtsi?h=LE.UM.1.3.r3.25#n2537 Signed-off-by: Marc Gonzalez <marc.w.gonzalez@xxxxxxx> --- Changes from v2: - Move all X-names props *after* corresponding X(s) prop - Drop comments --- arch/arm64/boot/dts/qcom/msm8998.dtsi | 69 +++++++++++++++++++++++++++ 1 file changed, 69 insertions(+) diff --git a/arch/arm64/boot/dts/qcom/msm8998.dtsi b/arch/arm64/boot/dts/qcom/msm8998.dtsi index f807ea3e2c6e..dab3333e21f4 100644 --- a/arch/arm64/boot/dts/qcom/msm8998.dtsi +++ b/arch/arm64/boot/dts/qcom/msm8998.dtsi @@ -621,6 +621,75 @@ <GIC_SPI 369 IRQ_TYPE_EDGE_RISING>; }; + pcie0: pci@1c00000 { + compatible = "qcom,pcie-msm8996"; + reg = <0x01c00000 0x2000>, + <0x1b000000 0xf1d>, + <0x1b000f20 0xa8>, + <0x1b100000 0x100000>; + reg-names = "parf", "dbi", "elbi", "config"; + device_type = "pci"; + linux,pci-domain = <0>; + bus-range = <0x00 0xff>; + #address-cells = <3>; + #size-cells = <2>; + num-lanes = <1>; + phys = <&pciephy>; + phy-names = "pciephy"; + + ranges = <0x01000000 0x0 0x1b200000 0x1b200000 0x0 0x100000>, + <0x02000000 0x0 0x1b300000 0x1b300000 0x0 0xd00000>; + + #interrupt-cells = <1>; + interrupts = <GIC_SPI 405 IRQ_TYPE_LEVEL_HIGH>; + interrupt-names = "msi"; + interrupt-map-mask = <0 0 0 0x7>; + interrupt-map = <0 0 0 1 &intc 0 135 IRQ_TYPE_LEVEL_HIGH>, + <0 0 0 2 &intc 0 136 IRQ_TYPE_LEVEL_HIGH>, + <0 0 0 3 &intc 0 138 IRQ_TYPE_LEVEL_HIGH>, + <0 0 0 4 &intc 0 139 IRQ_TYPE_LEVEL_HIGH>; + + clocks = <&gcc GCC_PCIE_0_PIPE_CLK>, + <&gcc GCC_PCIE_0_MSTR_AXI_CLK>, + <&gcc GCC_PCIE_0_SLV_AXI_CLK>, + <&gcc GCC_PCIE_0_CFG_AHB_CLK>, + <&gcc GCC_PCIE_0_AUX_CLK>; + clock-names = "pipe", "bus_master", "bus_slave", "cfg", "aux"; + + power-domains = <&gcc PCIE_0_GDSC>; + iommu-map = <0x100 &anoc1_smmu 0x1480 1>; + perst-gpios = <&tlmm 35 GPIO_ACTIVE_LOW>; + }; + + phy@1c06000 { + compatible = "qcom,msm8998-qmp-pcie-phy"; + reg = <0x01c06000 0x18c>; + #address-cells = <1>; + #size-cells = <1>; + ranges; + + clocks = <&gcc GCC_PCIE_PHY_AUX_CLK>, + <&gcc GCC_PCIE_0_CFG_AHB_CLK>, + <&gcc GCC_PCIE_CLKREF_CLK>; + clock-names = "aux", "cfg_ahb", "ref"; + + resets = <&gcc GCC_PCIE_0_PHY_BCR>, <&gcc GCC_PCIE_PHY_BCR>; + reset-names = "phy", "common"; + + vdda-phy-supply = <&vreg_l1a_0p875>; + vdda-pll-supply = <&vreg_l2a_1p2>; + + pciephy: lane@1c06800 { + reg = <0x01c06200 0x128>, <0x01c06400 0x1fc>, <0x01c06800 0x20c>; + #phy-cells = <0>; + + clocks = <&gcc GCC_PCIE_0_PIPE_CLK>; + clock-names = "pipe0"; + clock-output-names = "pcie_0_pipe_clk_src"; + #clock-cells = <0>; + }; + }; + tcsr_mutex_regs: syscon@1f40000 { compatible = "syscon"; reg = <0x1f40000 0x20000>; -- 2.17.1
