On Sun, Mar 11, 2018 at 11:03:58PM -0400, Sinan Kaya wrote: > On 3/11/2018 6:03 PM, Bjorn Helgaas wrote: > > On Wed, Feb 28, 2018 at 10:34:11PM +0530, Oza Pawandeep wrote: > > > That difference has been there since the beginning of DPC, so it has > > nothing to do with *this* series EXCEPT for the fact that it really > > complicates the logic you're adding to reset_link() and > > broadcast_error_message(). > > > > We ought to be able to simplify that somehow because the only real > > difference between AER and DPC should be that DPC automatically > > disables the link and AER does it in software. > > I agree this should be possible. Code execution path should be almost > identical to fatal error case. > > Is there any reason why you went to stop driver path, Keith? The fact is the link is truly down during a DPC event. When the link is enabled again, you don't know at that point if the device(s) on the other side have changed. Calling a driver's error handler for the wrong device in an unknown state may have undefined results. Enumerating the slot from scratch should be safe, and will assign resources, tune bus settings, and bind to the matching driver. Per spec, DPC is the recommended way for handling surprise removal events and even recommends DPC capable slots *not* set 'Surprise' in Slot Capabilities so that removals are always handled by DPC. This service driver was developed with that use in mind.
