On Wed, Jun 5, 2013 at 8:15 AM, Matt Fleming <matt@xxxxxxxxxxxxxxxxx> wrote:
> On Tue, 28 May, at 11:28:54AM, Bjorn Helgaas wrote:
>> OK, hopefully somebody will do the analysis to verify that ioremap()
>> is appropriate in both cases. It seems likely, but I haven't looked
>> in detail.
>
> Switching from early_ioremap() to ioremap() seems to work fine from the
> testing I've seen. I've included the new patch below. Would you prefer a
> proper submission?
This is fine, thanks. I applied this to my for-linus branch and will
ask Linus to pull it for v3.10.
> From 7a82fbe1d0c74533162487fa1e4bc23877a8a502 Mon Sep 17 00:00:00 2001
> From: Matt Fleming <matt.fleming@xxxxxxxxx>
> Date: Wed, 22 May 2013 09:56:23 +0100
> Subject: [PATCH] x86/PCI: setup data may be in highmem
>
> pcibios_add_device() assumes that the physical addresses stored in
> setup_data are accessible via the direct kernel mapping, and that
> calling phys_to_virt() is valid. This isn't guaranteed to be true on x86
> where the direct mapping range is much smaller than on x86-64.
>
> Calling phys_to_virt() on a highmem address results in the following,
>
> BUG: unable to handle kernel paging request at 39a3c198
> IP: [<c262be0f>] pcibios_add_device+0x2f/0x90
> *pde = 00000000
> Oops: 0000 [#1] SMP
> Modules linked in:
> Pid: 1, comm: swapper/0 Tainted: G W I 3.9.0-rc2+ #280
> EIP: 0060:[<c262be0f>] EFLAGS: 00010206 CPU: 1
> EIP is at pcibios_add_device+0x2f/0x90
> EAX: f6258800 EBX: f6258800 ECX: 79a3c190 EDX: 39a3c190
> ESI: f62d9814 EDI: f6258864 EBP: f60add38 ESP: f60add2c
> DS: 007b ES: 007b FS: 00d8 GS: 00e0 SS: 0068
> CR0: 8005003b CR2: 39a3c198 CR3: 02b91000 CR4: 001007d0
> DR0: 00000000 DR1: 00000000 DR2: 00000000 DR3: 00000000
> DR6: ffff0ff0 DR7: 00000400
> Process swapper/0 (pid: 1, ti=f60ac000 task=f60b0000 task.ti=f60ac000)
> Stack:
> f6258800 f62d9814 f6258864 f60add4c c2370c73 00000000 f62d9800 00000000
> f60add6c c274640b 0000ea60 f6258800 0f008086 f62d9800 f62d9800 00000000
> f60add84 c2370d08 00000000 00000008 f62d9800 00000000 f60adda4 c2371904
> Call Trace:
> [<c2370c73>] pci_device_add+0xe3/0x130
> [<c274640b>] pci_scan_single_device+0x8b/0xb0
> [<c2370d08>] pci_scan_slot+0x48/0x100
> [<c2371904>] pci_scan_child_bus+0x24/0xc0
> [<c262a7b0>] pci_acpi_scan_root+0x2c0/0x490
> [<c23b7203>] acpi_pci_root_add+0x312/0x42f
> [<c23b29d7>] ? acpi_device_notify_fixed+0x1d/0x1d
> [<c23b36a8>] acpi_bus_device_attach+0x77/0xdd
> [<c23cb6be>] acpi_ns_walk_namespace+0xb1/0x163
> [<c23b3631>] ? acpi_bus_type_and_status+0x82/0x82
> [<c23cbd4e>] acpi_walk_namespace+0x7e/0xa8
> [<c23b3631>] ? acpi_bus_type_and_status+0x82/0x82
> [<c23b46e0>] acpi_bus_scan+0x9a/0xa6
> [<c23b3631>] ? acpi_bus_type_and_status+0x82/0x82
> [<c2b17ec9>] acpi_scan_init+0x51/0x144
> [<c2b252a2>] ? pci_mmcfg_late_init+0x49/0x4b
> [<c2b17cdc>] acpi_init+0x224/0x28c
> [<c2001144>] do_one_initcall+0x34/0x170
> [<c2b17ab8>] ? acpi_sleep_proc_init+0x2e/0x2e
> [<c2aeeb83>] kernel_init_freeable+0x119/0x1b6
> [<c2aee4da>] ? do_early_param+0x74/0x74
> [<c2743f10>] kernel_init+0x10/0xd0
> [<c2765697>] ret_from_kernel_thread+0x1b/0x28
> [<c2743f00>] ? rest_init+0x60/0x60
>
> The most reliable way to trigger this crash seems to be booting a 32-bit
> kernel via the EFI boot stub.
>
> The solution is to use ioremap() instead of phys_to_virt() to map the
> setup data into the kernel address space.
>
> Tested-by: Jani Nikula <jani.nikula@xxxxxxxxx>
> Cc: Matthew Garrett <mjg59@xxxxxxxxxxxxx>
> Cc: Bjorn Helgaas <bhelgaas@xxxxxxxxxx>
> Cc: Seth Forshee <seth.forshee@xxxxxxxxxxxxx>
> Cc: Jesse Barnes <jbarnes@xxxxxxxxxxxxxxxx>
> Cc: <stable@xxxxxxxxxxxxxxx>
> Signed-off-by: Matt Fleming <matt.fleming@xxxxxxxxx>
> ---
> arch/x86/pci/common.c | 5 ++++-
> 1 file changed, 4 insertions(+), 1 deletion(-)
>
> diff --git a/arch/x86/pci/common.c b/arch/x86/pci/common.c
> index 305c68b..981c2db 100644
> --- a/arch/x86/pci/common.c
> +++ b/arch/x86/pci/common.c
> @@ -628,7 +628,9 @@ int pcibios_add_device(struct pci_dev *dev)
>
> pa_data = boot_params.hdr.setup_data;
> while (pa_data) {
> - data = phys_to_virt(pa_data);
> + data = ioremap(pa_data, sizeof(*rom));
> + if (!data)
> + return -ENOMEM;
>
> if (data->type == SETUP_PCI) {
> rom = (struct pci_setup_rom *)data;
> @@ -645,6 +647,7 @@ int pcibios_add_device(struct pci_dev *dev)
> }
> }
> pa_data = data->next;
> + iounmap(data);
> }
> return 0;
> }
> --
> 1.8.1.4
>
> --
> Matt Fleming, Intel Open Source Technology Center
--
To unsubscribe from this list: send the line "unsubscribe linux-pci" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
