Interesting. I'm using the "PCI Local Bus Specification, Rev. 3.0," but dated Feb 3, 2004. Sounds like they screwed up assigning revision numbers, and released two different things as "rev 3.0." Sigh. On Sat, Jun 1, 2013 at 5:30 AM, David Epping <david.epping@xxxxxxxxxxxxxxxxxxxxxxxxxx> wrote: > Bjorn, > > I found a ECN and presentation by PCI-SIG. Both documents describe exactly > the scheme you pointed out. > Seems I have been using an old or draft version. I will request the current > version right now. > > Thank you for your kind help and sorry for any confusion caused. > Best regards, > David > > > On 01.06.2013 01:33, David Epping wrote: >> >> On 01.06.2013 00:48, Bjorn Helgaas wrote: >>> >>> On Fri, May 31, 2013 at 4:14 PM, David Epping >>> <david.epping@xxxxxxxxxxxxxxxxxxxxxxxxxx> wrote: >>>> >>>> Hello, >>>> >>>> I am inspecting the MSI-X setup of some PCIe devices and have questions >>>> about the output of lspci. >>>> >>>> It looks something like this: >>>> Capabilities: [50] MSI-X: Enable+ Count=32 Masked- >>>> Vector table: BAR=0 offset=00002000 >>>> PBA: BAR=0 offset=00003000 >>>> >>>> As far as I understand the PCI 3.0 specification MSI-X capabilities >>>> define a >>>> 32 bit register for the upper address portion of the MSI target >>>> addresses >>>> (at capability offset 4) and another 32 bit register pointing to the BAR >>>> and >>>> inter-BAR offset for the table of lower address portions of the MSI >>>> target >>>> addresses (at capability offset 8). >>>> Why are there two lines in the lspci output indicating some BAR and >>>> offset? >>>> What do they mean? >>> >>> My understanding is that there are three data structures here: >>> 1) The MSI-X Capability (Figure 6-10) in config space >>> 2) The "MSI-X Table" (Figure 6-11) in PCI memory space >>> 3) The "MSI-X PBA" (Pending Bit Array, Figure 6-12) in PCI memory >>> space >>> >>> The "Vector table" line tells you how to find the "MSI-X Table," and >>> the "PBA" line tells you how to find the "MSI-X PBA" table. >>> >>> In MSI (not MSI-X), there is only one MSI target address, and it is in >>> the MSI capability. >>> >>> In MSI-X, each MSI-X vector can have its own target address, and those >>> addresses are not in the capability itself; they are stored in the >>> memory decoded by a BAR. >>> >>> In your case, you would read the bus address from BAR 0, and the >>> vector table should be at offsets 0x2000-0x21ff (32 16-byte entries) >>> from that address. The PBA should be at offsets 0x3000-0x30ff (32 >>> 8-byte entries). >>> >>> lspci will show you the BAR values, but it doesn't dump PCI memory >>> space, so you'd have to use /dev/mem or a tool like >>> http://cmp.felk.cvut.cz/~pisa/linux/rdwrmem.c to actually look at the >>> tables. >>> >>> Bjorn >>> -- >>> To unsubscribe from this list: send the line "unsubscribe linux-pci" in >>> the body of a message to majordomo@xxxxxxxxxxxxxxx >>> More majordomo info at http://vger.kernel.org/majordomo-info.html >> >> >> Bjorn, >> >> thank you for your quick reply. >> >> So far the concepts of MSI and MSI-X are clear. I did not have the meaning >> of the PBA acronym, but now I know what it stands for. >> I do however not see that reflected in the spec. As your figure references >> are off by one and I do not have the PBA figure, we should clarify the >> document used. I'm looking at PCI Local Bus Specification Revision 3.0 from >> August 2002. >> >> According to this document (and in case I'm reading it correctly) the >> pending bit is part of each MSI-X Vector Table entry (lowest bit in the >> address portion - section 6.8.2.6). The lspci source code and its output >> (and your explanation) however suggest that the pending bits are stored in a >> separate table. >> In addition this specification document has the common upper address >> portion of each MSI target address at capability offset 4 and the BAR and >> intra-BAR offset at capability offset 8. The pciutils source code defines >> the later to be at 4 and uses offset 8 to derive the PBA. >> >> I wonder where our disconnect is. What is the title and revision of the >> document you are referring to? >> Thanks again, >> David >> >> -- >> To unsubscribe from this list: send the line "unsubscribe linux-pci" in >> the body of a message to majordomo@xxxxxxxxxxxxxxx >> More majordomo info at http://vger.kernel.org/majordomo-info.html > > > -- > David Epping > david.epping@xxxxxxxxxxxxxxxxxxxxxxxxxx > Skype: david.epping > Mobile US: +1 (408) 4757-574 > Mobile DE: +49 (179) 9656-223 > > Missing Link Electronics > http://www.missinglinkelectronics.com > Office DE: +49 (731) 802-3930 > Office US: +1 (408) 457-0700 > Skype: missing.link.electronics > -- To unsubscribe from this list: send the line "unsubscribe linux-pci" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
