The current sequence in the driver for L1ss update is as follows.
Disable L1ss
Disable L1
Enable L1ss as required
Enable L1 if required
With this sequence, a bus hang is observed during the L1ss
disable sequence when the RC CPU attempts to clear the RC L1ss
register after clearing the EP L1ss register. It looks like the
RC attempts to enter L1ss again and at the same time, access to
RC L1ss register fails because aux clk is still not active.
PCIe spec r6.2, section 5.5.4, recommends that setting either
or both of the enable bits for ASPM L1 PM Substates must be done
while ASPM L1 is disabled. My interpretation here is that
clearing L1ss should also be done when L1 is disabled. Thereby,
change the sequence as follows.
Disable L1
Disable L1ss
Enable L1ss as required
Enable L1 if required
Signed-off-by: Ajay Agarwal <ajayagarwal@xxxxxxxxxx>
---
drivers/pci/pcie/aspm.c | 50 ++++++++++++++++++++---------------------
1 file changed, 24 insertions(+), 26 deletions(-)
diff --git a/drivers/pci/pcie/aspm.c b/drivers/pci/pcie/aspm.c
index cee2365e54b8..c172886129f3 100644
--- a/drivers/pci/pcie/aspm.c
+++ b/drivers/pci/pcie/aspm.c
@@ -848,17 +848,13 @@ static void pcie_aspm_cap_init(struct pcie_link_state *link, int blacklist)
/* Configure the ASPM L1 substates */
static void pcie_config_aspm_l1ss(struct pcie_link_state *link, u32 state)
{
- u32 val, enable_req;
+ u32 val;
struct pci_dev *child = link->downstream, *parent = link->pdev;
- enable_req = (link->aspm_enabled ^ state) & state;
-
/*
- * Here are the rules specified in the PCIe spec for enabling L1SS:
+ * Spec r6.2, section 5.5.4, mentions the rules for enabling L1SS:
* - When enabling L1.x, enable bit at parent first, then at child
* - When disabling L1.x, disable bit at child first, then at parent
- * - When enabling ASPM L1.x, need to disable L1
- * (at child followed by parent).
* - The ASPM/PCIPM L1.2 must be disabled while programming timing
* parameters
*
@@ -871,16 +867,6 @@ static void pcie_config_aspm_l1ss(struct pcie_link_state *link, u32 state)
PCI_L1SS_CTL1_L1SS_MASK, 0);
pci_clear_and_set_config_dword(parent, parent->l1ss + PCI_L1SS_CTL1,
PCI_L1SS_CTL1_L1SS_MASK, 0);
- /*
- * If needed, disable L1, and it gets enabled later
- * in pcie_config_aspm_link().
- */
- if (enable_req & (PCIE_LINK_STATE_L1_1 | PCIE_LINK_STATE_L1_2)) {
- pcie_capability_clear_word(child, PCI_EXP_LNKCTL,
- PCI_EXP_LNKCTL_ASPM_L1);
- pcie_capability_clear_word(parent, PCI_EXP_LNKCTL,
- PCI_EXP_LNKCTL_ASPM_L1);
- }
val = 0;
if (state & PCIE_LINK_STATE_L1_1)
@@ -937,21 +923,33 @@ static void pcie_config_aspm_link(struct pcie_link_state *link, u32 state)
dwstream |= PCI_EXP_LNKCTL_ASPM_L1;
}
+ /*
+ * Spec r6.2, section 5.5.4, recommends that setting either or both of
+ * the enable bits for ASPM L1 PM Substates must be done while ASPM L1
+ * is disabled. So disable L1 here, and it gets enabled later after the
+ * L1ss configuration has been completed.
+ *
+ * Spec r6.2, section 7.5.3.7, mentions that ASPM L1 must be enabled by
+ * software in the Upstream component on a Link prior to enabling ASPM
+ * L1 in the Downstream component on the Link. When disabling L1,
+ * software must disable ASPM L1 in the Downstream component on a Link
+ * prior to disabling ASPM L1 in the Upstream component on that Link.
+ *
+ * Spec doesn't mention L0s.
+ *
+ * Disable L1 and L0s here, and they get enabled later after the L1ss
+ * configuration has been completed.
+ */
+ list_for_each_entry(child, &linkbus->devices, bus_list)
+ pcie_config_aspm_dev(child, 0);
+ pcie_config_aspm_dev(parent, 0);
+
if (link->aspm_capable & PCIE_LINK_STATE_L1SS)
pcie_config_aspm_l1ss(link, state);
- /*
- * Spec 2.0 suggests all functions should be configured the
- * same setting for ASPM. Enabling ASPM L1 should be done in
- * upstream component first and then downstream, and vice
- * versa for disabling ASPM L1. Spec doesn't mention L0S.
- */
- if (state & PCIE_LINK_STATE_L1)
- pcie_config_aspm_dev(parent, upstream);
+ pcie_config_aspm_dev(parent, upstream);
list_for_each_entry(child, &linkbus->devices, bus_list)
pcie_config_aspm_dev(child, dwstream);
- if (!(state & PCIE_LINK_STATE_L1))
- pcie_config_aspm_dev(parent, upstream);
link->aspm_enabled = state;
--
2.46.1.824.gd892dcdcdd-goog
