Our HW design has again changed a register offset which used to be standard
for all Broadcom SOCs with PCIe cores. This difference is now reconciled
for the registers HARD_DEBUG and INTR2_CPU_BASE.
Signed-off-by: Jim Quinlan <james.quinlan@xxxxxxxxxxxx>
---
drivers/pci/controller/pcie-brcmstb.c | 33 +++++++++++++++++----------
1 file changed, 21 insertions(+), 12 deletions(-)
diff --git a/drivers/pci/controller/pcie-brcmstb.c b/drivers/pci/controller/pcie-brcmstb.c
index 59daa4b2e6c5..d8c0f1474369 100644
--- a/drivers/pci/controller/pcie-brcmstb.c
+++ b/drivers/pci/controller/pcie-brcmstb.c
@@ -122,7 +122,6 @@
#define PCIE_MEM_WIN0_LIMIT_HI(win) \
PCIE_MISC_CPU_2_PCIE_MEM_WIN0_LIMIT_HI + ((win) * 8)
-#define PCIE_MISC_HARD_PCIE_HARD_DEBUG 0x4204
#define PCIE_MISC_HARD_PCIE_HARD_DEBUG_CLKREQ_DEBUG_ENABLE_MASK 0x2
#define PCIE_MISC_HARD_PCIE_HARD_DEBUG_L1SS_ENABLE_MASK 0x200000
#define PCIE_MISC_HARD_PCIE_HARD_DEBUG_SERDES_IDDQ_MASK 0x08000000
@@ -131,9 +130,9 @@
(PCIE_MISC_HARD_PCIE_HARD_DEBUG_CLKREQ_DEBUG_ENABLE_MASK | \
PCIE_MISC_HARD_PCIE_HARD_DEBUG_L1SS_ENABLE_MASK)
-#define PCIE_INTR2_CPU_BASE 0x4300
#define PCIE_MSI_INTR2_BASE 0x4500
-/* Offsets from PCIE_INTR2_CPU_BASE and PCIE_MSI_INTR2_BASE */
+
+/* Offsets from INTR2_CPU and MSI_INTR2 BASE offsets */
#define MSI_INT_STATUS 0x0
#define MSI_INT_CLR 0x8
#define MSI_INT_MASK_SET 0x10
@@ -187,6 +186,8 @@
#define IDX_ADDR(pcie) (pcie->reg_offsets[EXT_CFG_INDEX])
#define DATA_ADDR(pcie) (pcie->reg_offsets[EXT_CFG_DATA])
#define PCIE_RGR1_SW_INIT_1(pcie) (pcie->reg_offsets[RGR1_SW_INIT_1])
+#define HARD_DEBUG(pcie) (pcie->reg_offsets[PCIE_HARD_DEBUG])
+#define INTR2_CPU_BASE(pcie) (pcie->reg_offsets[PCIE_INTR2_CPU_BASE])
/* Rescal registers */
#define PCIE_DVT_PMU_PCIE_PHY_CTRL 0xc700
@@ -205,6 +206,8 @@ enum {
RGR1_SW_INIT_1,
EXT_CFG_INDEX,
EXT_CFG_DATA,
+ PCIE_HARD_DEBUG,
+ PCIE_INTR2_CPU_BASE,
};
enum {
@@ -651,7 +654,7 @@ static int brcm_pcie_enable_msi(struct brcm_pcie *pcie)
BUILD_BUG_ON(BRCM_INT_PCI_MSI_LEGACY_NR > BRCM_INT_PCI_MSI_NR);
if (msi->legacy) {
- msi->intr_base = msi->base + PCIE_INTR2_CPU_BASE;
+ msi->intr_base = msi->base + INTR2_CPU_BASE(pcie);
msi->nr = BRCM_INT_PCI_MSI_LEGACY_NR;
msi->legacy_shift = 24;
} else {
@@ -898,12 +901,12 @@ static int brcm_pcie_setup(struct brcm_pcie *pcie)
/* Take the bridge out of reset */
pcie->bridge_sw_init_set(pcie, 0);
- tmp = readl(base + PCIE_MISC_HARD_PCIE_HARD_DEBUG);
+ tmp = readl(base + HARD_DEBUG(pcie));
if (is_bmips(pcie))
tmp &= ~PCIE_BMIPS_MISC_HARD_PCIE_HARD_DEBUG_SERDES_IDDQ_MASK;
else
tmp &= ~PCIE_MISC_HARD_PCIE_HARD_DEBUG_SERDES_IDDQ_MASK;
- writel(tmp, base + PCIE_MISC_HARD_PCIE_HARD_DEBUG);
+ writel(tmp, base + HARD_DEBUG(pcie));
/* Wait for SerDes to be stable */
usleep_range(100, 200);
@@ -1072,7 +1075,7 @@ static void brcm_config_clkreq(struct brcm_pcie *pcie)
}
/* Start out assuming safe mode (both mode bits cleared) */
- clkreq_cntl = readl(pcie->base + PCIE_MISC_HARD_PCIE_HARD_DEBUG);
+ clkreq_cntl = readl(pcie->base + HARD_DEBUG(pcie));
clkreq_cntl &= ~PCIE_CLKREQ_MASK;
if (strcmp(mode, "no-l1ss") == 0) {
@@ -1115,7 +1118,7 @@ static void brcm_config_clkreq(struct brcm_pcie *pcie)
dev_err(pcie->dev, err_msg);
mode = "safe";
}
- writel(clkreq_cntl, pcie->base + PCIE_MISC_HARD_PCIE_HARD_DEBUG);
+ writel(clkreq_cntl, pcie->base + HARD_DEBUG(pcie));
dev_info(pcie->dev, "clkreq-mode set to %s\n", mode);
}
@@ -1337,9 +1340,9 @@ static void brcm_pcie_turn_off(struct brcm_pcie *pcie)
writel(tmp, base + PCIE_MISC_PCIE_CTRL);
/* Turn off SerDes */
- tmp = readl(base + PCIE_MISC_HARD_PCIE_HARD_DEBUG);
+ tmp = readl(base + HARD_DEBUG(pcie));
u32p_replace_bits(&tmp, 1, PCIE_MISC_HARD_PCIE_HARD_DEBUG_SERDES_IDDQ_MASK);
- writel(tmp, base + PCIE_MISC_HARD_PCIE_HARD_DEBUG);
+ writel(tmp, base + HARD_DEBUG(pcie));
/* Shutdown PCIe bridge */
pcie->bridge_sw_init_set(pcie, 1);
@@ -1425,9 +1428,9 @@ static int brcm_pcie_resume_noirq(struct device *dev)
pcie->bridge_sw_init_set(pcie, 0);
/* SERDES_IDDQ = 0 */
- tmp = readl(base + PCIE_MISC_HARD_PCIE_HARD_DEBUG);
+ tmp = readl(base + HARD_DEBUG(pcie));
u32p_replace_bits(&tmp, 0, PCIE_MISC_HARD_PCIE_HARD_DEBUG_SERDES_IDDQ_MASK);
- writel(tmp, base + PCIE_MISC_HARD_PCIE_HARD_DEBUG);
+ writel(tmp, base + HARD_DEBUG(pcie));
/* wait for serdes to be stable */
udelay(100);
@@ -1499,12 +1502,16 @@ static const int pcie_offsets[] = {
[RGR1_SW_INIT_1] = 0x9210,
[EXT_CFG_INDEX] = 0x9000,
[EXT_CFG_DATA] = 0x9004,
+ [PCIE_HARD_DEBUG] = 0x4204,
+ [PCIE_INTR2_CPU_BASE] = 0x4300,
};
static const int pcie_offsets_bmips_7425[] = {
[RGR1_SW_INIT_1] = 0x8010,
[EXT_CFG_INDEX] = 0x8300,
[EXT_CFG_DATA] = 0x8304,
+ [PCIE_HARD_DEBUG] = 0x4204,
+ [PCIE_INTR2_CPU_BASE] = 0x4300,
};
static const struct pcie_cfg_data generic_cfg = {
@@ -1539,6 +1546,8 @@ static const int pcie_offset_bcm7278[] = {
[RGR1_SW_INIT_1] = 0xc010,
[EXT_CFG_INDEX] = 0x9000,
[EXT_CFG_DATA] = 0x9004,
+ [PCIE_HARD_DEBUG] = 0x4204,
+ [PCIE_INTR2_CPU_BASE] = 0x4300,
};
static const struct pcie_cfg_data bcm7278_cfg = {
--
2.17.1
Attachment:
smime.p7s
Description: S/MIME Cryptographic Signature
