On Sat, Dec 30, 2023 at 12:45:49PM +0100, Lukas Wunner wrote: > On Fri, Sep 29, 2023 at 02:57:18PM +0300, Ilpo Järvinen wrote: > > struct pci_bus stores max_bus_speed. Implementation Note in PCIe r6.0.1 > > sec 7.5.3.18, however, recommends determining supported Link Speeds > > using the Supported Link Speeds Vector in the Link Capabilities 2 > > Register (when available). > > > > Add pcie_bus_speeds into struct pci_bus which caches the Supported Link > > Speeds. The value is taken directly from the Supported Link Speeds > > Vector or synthetized from the Max Link Speed in the Link Capabilities > > Register when the Link Capabilities 2 Register is not available. > > Remind me, what's the reason again to cache this and why is > max_bus_speed not sufficient? Is the point that there may be > "gaps" in the supported link speeds, i.e. not every bit below > the maximum supported speed may be set? And you need to skip > over those gaps when throttling to a lower speed? FWIW I went and re-read the internal review I provided on May 18. Turns out I already mentioned back then that gaps aren't permitted: "Per PCIe r6.0.1 sec 8.2.1, the bitfield in the Link Capabilities 2 register is not permitted to contain gaps between maximum supported speed and lowest possible speed (2.5 GT/s Gen1)." > Also, I note that pci_set_bus_speed() doesn't use LNKCAP2. About that, I wrote in May: "Actually, scratch that. pci_set_bus_speed() is fine. Since it's only interested in the *maximum* link speed, reading just LnkCap is correct. LnkCap2 only needs to be read to determine if a certain speed is *supported*. E.g., even though 32 GT/s are supported, perhaps 16 GT/s are not. It's rather pcie_get_speed_cap() which should be changed. There's no need for it to read LnkCap2. The commit which introduced this, 6cf57be0f78e, was misguided and had to be fixed up with f1f90e254e46. It could be simplified to just read LnkCap and return pcie_link_speed[linkcap & PCI_EXP_LNKCAP_SLS]. If the device is a Root Port or Downstream Port, it doesn't even have to do that but could return the cached value in subordinate->max_bus_speed. If you add another attribute to struct pci_bus for the downstream device's maximum speed, the maximum speed for Endpoints and Upstream Ports could be returned directly as well from that attribute." Thanks, Lukas
