On Fri, Nov 24, 2023 at 09:45:08AM +0800, Kevin Xie wrote: > Add the PCIE_CONFIG_REQUEST_WAIT_MS marco to define the minimum waiting > time between sending the first configuration request to the device and > exit from a conventional reset (or after link training completes). > > As described in the conventional reset rules of PCI specifications, > there are two different use cases of the value: > > - With a downstream port that supports link speeds <= 5.0 GT/s, > the waiting is following exit from a conventional reset. > > - With a downstream port that supports link speeds > 5.0 GT/s, > the waiting is after link training completes. > > Signed-off-by: Kevin Xie <kevin.xie@xxxxxxxxxxxxxxxx> > Reviewed-by: Mason Huo <mason.huo@xxxxxxxxxxxxxxxx> > --- > drivers/pci/pci.h | 7 +++++++ > 1 file changed, 7 insertions(+) > > diff --git a/drivers/pci/pci.h b/drivers/pci/pci.h > index 5ecbcf041179..4ca8766e546e 100644 > --- a/drivers/pci/pci.h > +++ b/drivers/pci/pci.h > @@ -22,6 +22,13 @@ > */ > #define PCIE_PME_TO_L2_TIMEOUT_US 10000 > > +/* > + * PCIe r6.0, sec 6.6.1, <Conventional Reset> > + * Requires a minimum waiting of 100ms before sending a configuration > + * request to the device. > + */ > +#define PCIE_CONFIG_REQUEST_WAIT_MS 100 Oh, and I think this name should include something about "reset" because that's the common scenario and that's the spec section where the value is mentioned.
