Re: [PATCH v7 2/4] PCI: dwc: rockchip: add legacy interrupt support

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Sat, Apr 16, 2022 at 8:54 AM Marc Zyngier <maz@xxxxxxxxxx> wrote:
>
> Peter,
>
> May I suggest that you slow down on the number of versions you send?
> This is the 7th in 5 days, the 3rd today.
>
> At this stage, this is entirely counterproductive.

Apologies, I'll be sure to be at least one cup of coffee in before
doing early morning code.

>
> On 2022-04-16 12:05, Peter Geis wrote:
> > The legacy interrupts on the rk356x pcie controller are handled by a
> > single muxed interrupt. Add irq domain support to the pcie-dw-rockchip
> > driver to support the virtual domain.
> >
> > Signed-off-by: Peter Geis <pgwipeout@xxxxxxxxx>
> > ---
> >  drivers/pci/controller/dwc/pcie-dw-rockchip.c | 112 +++++++++++++++++-
> >  1 file changed, 110 insertions(+), 2 deletions(-)
> >
> > diff --git a/drivers/pci/controller/dwc/pcie-dw-rockchip.c
> > b/drivers/pci/controller/dwc/pcie-dw-rockchip.c
> > index c9b341e55cbb..863374604fb1 100644
> > --- a/drivers/pci/controller/dwc/pcie-dw-rockchip.c
> > +++ b/drivers/pci/controller/dwc/pcie-dw-rockchip.c
> > @@ -10,9 +10,12 @@
> >
> >  #include <linux/clk.h>
> >  #include <linux/gpio/consumer.h>
> > +#include <linux/irqchip/chained_irq.h>
> > +#include <linux/irqdomain.h>
> >  #include <linux/mfd/syscon.h>
> >  #include <linux/module.h>
> >  #include <linux/of_device.h>
> > +#include <linux/of_irq.h>
> >  #include <linux/phy/phy.h>
> >  #include <linux/platform_device.h>
> >  #include <linux/regmap.h>
> > @@ -36,10 +39,13 @@
> >  #define PCIE_LINKUP                  (PCIE_SMLH_LINKUP | PCIE_RDLH_LINKUP)
> >  #define PCIE_L0S_ENTRY                       0x11
> >  #define PCIE_CLIENT_GENERAL_CONTROL  0x0
> > +#define PCIE_CLIENT_INTR_STATUS_LEGACY       0x8
> > +#define PCIE_CLIENT_INTR_MASK_LEGACY 0x1c
> >  #define PCIE_CLIENT_GENERAL_DEBUG    0x104
> > -#define PCIE_CLIENT_HOT_RESET_CTRL      0x180
> > +#define PCIE_CLIENT_HOT_RESET_CTRL   0x180
> >  #define PCIE_CLIENT_LTSSM_STATUS     0x300
> > -#define PCIE_LTSSM_ENABLE_ENHANCE       BIT(4)
> > +#define PCIE_LEGACY_INT_ENABLE               GENMASK(3, 0)
> > +#define PCIE_LTSSM_ENABLE_ENHANCE    BIT(4)
> >  #define PCIE_LTSSM_STATUS_MASK               GENMASK(5, 0)
> >
> >  struct rockchip_pcie {
> > @@ -51,6 +57,8 @@ struct rockchip_pcie {
> >       struct reset_control            *rst;
> >       struct gpio_desc                *rst_gpio;
> >       struct regulator                *vpcie3v3;
> > +     struct irq_domain               *irq_domain;
> > +     raw_spinlock_t                  irq_lock;
> >  };
> >
> >  static int rockchip_pcie_readl_apb(struct rockchip_pcie *rockchip,
> > @@ -65,6 +73,94 @@ static void rockchip_pcie_writel_apb(struct
> > rockchip_pcie *rockchip,
> >       writel_relaxed(val, rockchip->apb_base + reg);
> >  }
> >
> > +static void rockchip_pcie_legacy_int_handler(struct irq_desc *desc)
> > +{
> > +     struct irq_chip *chip = irq_desc_get_chip(desc);
> > +     struct rockchip_pcie *rockchip = irq_desc_get_handler_data(desc);
> > +     unsigned long reg, hwirq;
> > +
> > +     chained_irq_enter(chip, desc);
> > +
> > +     reg = rockchip_pcie_readl_apb(rockchip,
> > PCIE_CLIENT_INTR_STATUS_LEGACY);
> > +
> > +     for_each_set_bit(hwirq, &reg, 8)
>
> 8? And yet:
>
> #define PCI_NUM_INTX        4
>
> So whatever bits are set above bit 3, you are feeding garbage
> to the irqdomain code.

There are 8 bits in total, the top four are for the TX interrupts, for
which EP mode is not yet supported by the driver.
I can constrain this further and let it be expanded when that support
is added, if that works for you?

>
> > +             generic_handle_domain_irq(rockchip->irq_domain, hwirq);
> > +
> > +     chained_irq_exit(chip, desc);
> > +}
> > +
> > +static void rockchip_intx_mask(struct irq_data *data)
> > +{
> > +     struct rockchip_pcie *rockchip = irq_data_get_irq_chip_data(data);
> > +     unsigned long flags;
> > +     u32 val;
> > +
> > +     /* disable legacy interrupts */
> > +     raw_spin_lock_irqsave(&rockchip->irq_lock, flags);
> > +     val = HIWORD_UPDATE_BIT(PCIE_LEGACY_INT_ENABLE);
> > +     val |= PCIE_LEGACY_INT_ENABLE;
> > +     rockchip_pcie_writel_apb(rockchip, val,
> > PCIE_CLIENT_INTR_MASK_LEGACY);
> > +     raw_spin_unlock_irqrestore(&rockchip->irq_lock, flags);
>
> This is completely busted. INTx lines must be controlled individually.
> If I disable one device's INTx output, I don't want to see the
> interrupt firing because another one has had its own enabled.

Okay, that makes sense. I'm hitting the entire block when it should be
the individual IRQ.
I also notice some drivers protect this with a spinlock while others
do not, how should this be handled?

>
>          M.
> --
> Jazz is not dead. It just smells funny...

Thanks Again!



[Index of Archives]     [DMA Engine]     [Linux Coverity]     [Linux USB]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Greybus]

  Powered by Linux