Peter,
May I suggest that you slow down on the number of versions you send?
This is the 7th in 5 days, the 3rd today.
At this stage, this is entirely counterproductive.
On 2022-04-16 12:05, Peter Geis wrote:
The legacy interrupts on the rk356x pcie controller are handled by a
single muxed interrupt. Add irq domain support to the pcie-dw-rockchip
driver to support the virtual domain.
Signed-off-by: Peter Geis <pgwipeout@xxxxxxxxx>
---
drivers/pci/controller/dwc/pcie-dw-rockchip.c | 112 +++++++++++++++++-
1 file changed, 110 insertions(+), 2 deletions(-)
diff --git a/drivers/pci/controller/dwc/pcie-dw-rockchip.c
b/drivers/pci/controller/dwc/pcie-dw-rockchip.c
index c9b341e55cbb..863374604fb1 100644
--- a/drivers/pci/controller/dwc/pcie-dw-rockchip.c
+++ b/drivers/pci/controller/dwc/pcie-dw-rockchip.c
@@ -10,9 +10,12 @@
#include <linux/clk.h>
#include <linux/gpio/consumer.h>
+#include <linux/irqchip/chained_irq.h>
+#include <linux/irqdomain.h>
#include <linux/mfd/syscon.h>
#include <linux/module.h>
#include <linux/of_device.h>
+#include <linux/of_irq.h>
#include <linux/phy/phy.h>
#include <linux/platform_device.h>
#include <linux/regmap.h>
@@ -36,10 +39,13 @@
#define PCIE_LINKUP (PCIE_SMLH_LINKUP | PCIE_RDLH_LINKUP)
#define PCIE_L0S_ENTRY 0x11
#define PCIE_CLIENT_GENERAL_CONTROL 0x0
+#define PCIE_CLIENT_INTR_STATUS_LEGACY 0x8
+#define PCIE_CLIENT_INTR_MASK_LEGACY 0x1c
#define PCIE_CLIENT_GENERAL_DEBUG 0x104
-#define PCIE_CLIENT_HOT_RESET_CTRL 0x180
+#define PCIE_CLIENT_HOT_RESET_CTRL 0x180
#define PCIE_CLIENT_LTSSM_STATUS 0x300
-#define PCIE_LTSSM_ENABLE_ENHANCE BIT(4)
+#define PCIE_LEGACY_INT_ENABLE GENMASK(3, 0)
+#define PCIE_LTSSM_ENABLE_ENHANCE BIT(4)
#define PCIE_LTSSM_STATUS_MASK GENMASK(5, 0)
struct rockchip_pcie {
@@ -51,6 +57,8 @@ struct rockchip_pcie {
struct reset_control *rst;
struct gpio_desc *rst_gpio;
struct regulator *vpcie3v3;
+ struct irq_domain *irq_domain;
+ raw_spinlock_t irq_lock;
};
static int rockchip_pcie_readl_apb(struct rockchip_pcie *rockchip,
@@ -65,6 +73,94 @@ static void rockchip_pcie_writel_apb(struct
rockchip_pcie *rockchip,
writel_relaxed(val, rockchip->apb_base + reg);
}
+static void rockchip_pcie_legacy_int_handler(struct irq_desc *desc)
+{
+ struct irq_chip *chip = irq_desc_get_chip(desc);
+ struct rockchip_pcie *rockchip = irq_desc_get_handler_data(desc);
+ unsigned long reg, hwirq;
+
+ chained_irq_enter(chip, desc);
+
+ reg = rockchip_pcie_readl_apb(rockchip,
PCIE_CLIENT_INTR_STATUS_LEGACY);
+
+ for_each_set_bit(hwirq, ®, 8)
8? And yet:
#define PCI_NUM_INTX 4
So whatever bits are set above bit 3, you are feeding garbage
to the irqdomain code.
+ generic_handle_domain_irq(rockchip->irq_domain, hwirq);
+
+ chained_irq_exit(chip, desc);
+}
+
+static void rockchip_intx_mask(struct irq_data *data)
+{
+ struct rockchip_pcie *rockchip = irq_data_get_irq_chip_data(data);
+ unsigned long flags;
+ u32 val;
+
+ /* disable legacy interrupts */
+ raw_spin_lock_irqsave(&rockchip->irq_lock, flags);
+ val = HIWORD_UPDATE_BIT(PCIE_LEGACY_INT_ENABLE);
+ val |= PCIE_LEGACY_INT_ENABLE;
+ rockchip_pcie_writel_apb(rockchip, val,
PCIE_CLIENT_INTR_MASK_LEGACY);
+ raw_spin_unlock_irqrestore(&rockchip->irq_lock, flags);
This is completely busted. INTx lines must be controlled individually.
If I disable one device's INTx output, I don't want to see the
interrupt firing because another one has had its own enabled.
M.
--
Jazz is not dead. It just smells funny...
