On 2/23/2022 12:52 AM, Nirmal Patel wrote: > vmd creates and assigns separate irq domain only when MSI remapping is > enabled. For example VMD-MSI. But vmd doesn't assign irq domain when > MSI remapping is disabled resulting child devices getting default > PCI-MSI irq domain. Now when Interrupt remapping is enabled all the > pci devices are assigned INTEL-IR-MSI domain including vmd endpoints. > But devices behind vmd gets PCI-MSI irq domain when vmd creates root > bus and configures child devices. > > As a result DMAR errors were observed when interrupt remapping was > enabled on Intel Icelake CPUs. > For instance: > DMAR: DRHD: handling fault status reg 2 > DMAR: [INTR-REMAP] Request device [0xe2:0x00.0] fault index 0xa00 > [fault reason 0x25] Blocked a compatibility format interrupt request > > So make sure vmd assigns proper irq domain. This patch also removes > a placeholder patch 2565e5b69c44 (PCI: vmd: Do not disable MSI-X > remapping if interrupt remapping is enabled by IOMMU.) MSI remapping > should be enabled or disabled with and without Interrupt remap. > > Signed-off-by: Nirmal Patel <nirmal.patel@xxxxxxxxxxxxxxx> > --- > drivers/pci/controller/vmd.c | 7 ++++--- > 1 file changed, 4 insertions(+), 3 deletions(-) > > diff --git a/drivers/pci/controller/vmd.c b/drivers/pci/controller/vmd.c > index cc166c683638..c8d73d75a1c0 100644 > --- a/drivers/pci/controller/vmd.c > +++ b/drivers/pci/controller/vmd.c > @@ -813,8 +813,7 @@ static int vmd_enable_domain(struct vmd_dev *vmd, unsigned long features) > * acceptable because the guest is usually CPU-limited and MSI > * remapping doesn't become a performance bottleneck. > */ > - if (iommu_capable(vmd->dev->dev.bus, IOMMU_CAP_INTR_REMAP) || > - !(features & VMD_FEAT_CAN_BYPASS_MSI_REMAP) || > + if (!(features & VMD_FEAT_CAN_BYPASS_MSI_REMAP) || > offset[0] || offset[1]) { > ret = vmd_alloc_irqs(vmd); > if (ret) > @@ -853,7 +852,9 @@ static int vmd_enable_domain(struct vmd_dev *vmd, unsigned long features) > vmd_attach_resources(vmd); > if (vmd->irq_domain) > dev_set_msi_domain(&vmd->bus->dev, vmd->irq_domain); > - > + else > + dev_set_msi_domain(&vmd->bus->dev, vmd->dev->dev.msi.domain); > + > vmd_acpi_begin(); > > pci_scan_child_bus(vmd->bus); Gentle ping! Thanks nirmal