On Mon, Feb 07, 2022 at 04:51:23PM +0200, Baruch Siach wrote: > This series adds support for the single PCIe lane on IPQ6018 SoCs. The code is > ported from downstream Codeaurora v5.4 kernel. The main difference from > downstream code is the split of PCIe registers configuration from .init to > .post_init, since it requires phy_power_on(). > > Tested on IPQ6010 based hardware. > > Changes in v6: > > * Drop DT patch applied to the qcom tree > > * Normalize driver changes subject line > > * Add a preparatory patch to rename PCIE_CAP_LINK1_VAL to PCIE_CAP_SLOT_VAL, > and define it using PCI_EXP_SLTCAP_* macros > > * Drop a vague comment about ASPM configuration > > * Add a comment about the source of delay periods > > Changes in v5: > > * Remove comments from qcom_pcie_init_2_9_0() (Bjorn Andersson) > > Changes in v4: > > * Drop applied DT bits > > * Add max-link-speed that was missing from the applied v2 patch > > * Rebase the driver on v5.16-rc3 > > Changes in v3: > > * Drop applied patches > > * Rely on generic code for speed setup > > * Drop unused macros > > * Formatting fixes > > Changes in v2: > > * Add patch moving GEN3_RELATED macros to a common header > > * Drop ATU configuration from pcie-qcom > > * Remove local definition of common registers > > * Use bulk clk and reset APIs > > * Remove msi-parent from device-tree > > Baruch Siach (2): > PCI: dwc: tegra: move GEN3_RELATED DBI register to common header > PCI: qcom: Define slot capabilities using PCI_EXP_SLTCAP_* > > Selvam Sathappan Periakaruppan (1): > PCI: qcom: Add IPQ60xx support > > drivers/pci/controller/dwc/pcie-designware.h | 7 + > drivers/pci/controller/dwc/pcie-qcom.c | 155 ++++++++++++++++++- > drivers/pci/controller/dwc/pcie-tegra194.c | 6 - > 3 files changed, 160 insertions(+), 8 deletions(-) Bjorn, Andy, Can you ACK please if this series is ready to be merged ? Thanks, Lorenzo
