While the Apple PCIe driver works correctly when directly booted
from the firmware, it fails to initialise when the kernel is booted
from a bootloader using PCIe such as u-boot.
That's beacuse we're missing a proper reset of the port (we only
clear the reset, but never assert it).
The PCIe spec requirements are two-fold:
- #PERST must be asserted before setting up the clocks, and
stay asserted for at least 100us (Tperst-clk).
- Once #PERST is deasserted, the OS must wait for at least 100ms
"from the end of a Conventional Reset" before we can start talking
to the devices
Implementing this results in a booting system.
Fixes: 1e33888fbe44 ("PCI: apple: Add initial hardware bring-up")
Acked-by: Pali Rohár <pali@xxxxxxxxxx>
Signed-off-by: Marc Zyngier <maz@xxxxxxxxxx>
Cc: Alyssa Rosenzweig <alyssa@xxxxxxxxxxxxx>
Cc: Lorenzo Pieralisi <lorenzo.pieralisi@xxxxxxx>
Cc: Bjorn Helgaas <bhelgaas@xxxxxxxxxx>
---
drivers/pci/controller/pcie-apple.c | 10 ++++++++++
1 file changed, 10 insertions(+)
diff --git a/drivers/pci/controller/pcie-apple.c b/drivers/pci/controller/pcie-apple.c
index 1bf4d75b61be..957960a733c4 100644
--- a/drivers/pci/controller/pcie-apple.c
+++ b/drivers/pci/controller/pcie-apple.c
@@ -539,13 +539,23 @@ static int apple_pcie_setup_port(struct apple_pcie *pcie,
rmw_set(PORT_APPCLK_EN, port->base + PORT_APPCLK);
+ /* Engage #PERST before setting up the clock */
+ gpiod_set_value(reset, 0);
+
ret = apple_pcie_setup_refclk(pcie, port);
if (ret < 0)
return ret;
+ /* The minimal Tperst-clk value is 100us (PCIe CMS r2.0, 2.6.2) */
+ usleep_range(100, 200);
+
+ /* Deassert #PERST */
rmw_set(PORT_PERST_OFF, port->base + PORT_PERST);
gpiod_set_value(reset, 1);
+ /* Wait for 100ms after #PERST deassertion (PCIe r2.0, 6.6.1) */
+ msleep(100);
+
ret = readl_relaxed_poll_timeout(port->base + PORT_STATUS, stat,
stat & PORT_STATUS_READY, 100, 250000);
if (ret < 0) {
--
2.30.2
