On Thu, May 19, 2011 at 3:27 PM, Jan Zwiegers <jan@xxxxxxxxxxxxxxxxxxxx> wrote: > On 2011-05-19 08:50 PM, Bjorn Helgaas wrote: >> >> On Thu, May 19, 2011 at 10:28 AM, Jan Zwiegers<jan@xxxxxxxxxxxxxxxxxxxx> >> Âwrote: >>> >>> I have the problem below where my PCI card's second BAR does not get >>> assigned. >>> What can be the cause of this problem? >>> The last kernel I tested on which worked OK was 2.6.27. >>> My current problematic kernel 2.6.35. >>> >>> 05:01.0 Unassigned class [ff00]: Eagle Technology PCI-703 Analog I/O Card >>> (rev 5c) >>> Â ÂFlags: bus master, slow devsel, latency 32, IRQ 22 >>> Â ÂMemory at 93b00000 (type 3, prefetchable) [size=2K] >>> Â ÂMemory at<unassigned> Â(type 3, prefetchable) >>> Â ÂCapabilities: [80] #00 [0600] >>> Â ÂKernel modules: pci703drv >> >> Could be resource exhaustion or, more likely, we ran out because we >> now assign resource to things that don't need them, leaving none for >> things that *do* need them. ÂThis sounds like a regression, so we >> should open a bugzilla for it and attach dmesg logs from 2.6.27 and >> 2.6.35. >> >> Does this problem keep the driver from working? Â(Sometimes drivers >> don't actually use all the BARs a device supports.) >> >> Bjorn >> > > I'm the maintainer of the driver and was involved in the development of the > board as well in 2003. The board uses two BARS and the second BAR is the > most important. The board worked fine since the 2.4 days and only recently > became problematic. I suspect it works on even later kernels than 27, maybe > 2.6.32. > > My knowledge is too little to actually determine if the problem is because > the FPGA based PCI interface is not within spec or something that changed in > the kernel, because of the post .30 releases becoming more strict to PCI > specification, i.e. BIOS / Kernel interaction. > > Jan > -- > To unsubscribe from this list: send the line "unsubscribe linux-pci" in > the body of a message to majordomo@xxxxxxxxxxxxxxx > More majordomo info at Âhttp://vger.kernel.org/majordomo-info.html > What's the size for BAR1? one reason is that no more space to align/allocate BAR1. If the board stays the same then your FPGA might be the cause, I have seen similar issues and they ended up in FPGA implementation. -- To unsubscribe from this list: send the line "unsubscribe linux-pci" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
