On 10/25/2013 06:46 AM, Tomi Valkeinen wrote:
> On 25/10/13 14:14, Nishanth Menon wrote:
>
>> lcd2_pins: pinmux_lcd2_pins {
>> + pinctrl-single,pins = <
>> + 0x20 (PIN_OUTPUT_PULLDOWN | MUX_MODE3) /* gpio_40 */
>> + 0x46 (PIN_OUTPUT_PULLUP | MUX_MODE3) /* gpio_59 */
>> + 0x56 (PIN_OUTPUT_PULLDOWN | MUX_MODE3) /* gpio_104 */
>> + >;
>>
>> 3 pins are driven around 300uA at boot, even with display OFF -> which
>> means wasted current that could have been optimized by hooking the pin
>> to the dts node corresponding to the device and used by the driver
>> appropriately.
>
> One more clarification question.
>
> The gpio 40 is used to enable powers for the picodlp. Shouldn't that one
> have a pinctrl pull-down in any case? If it's left floating, and the
> driver is not compiled in or doesn't start, the powers could get enabled
> depending on sunspot, right?
>
> And I guess the same goes for all gpios used to enable something.
>
Fair question. The selection of pull up, gpio control needs to be
balanced.
if the peripheral in question has a regulator controlled supply, none
of the pins would matter - driver can adequately sequence this to
ensure there are no weird side-effects. in such a scenario, i'd have a
default MODE3 with no pulls, sequence as follows:
a) control gpio to required default level (disabled)
b) control regulator
c) set GPIO to enable.
if the peripheral in question is always on and controlled with just a
enable pin, it is safer to keep the pin muxed with weak pull.
If the enable has no real functional impact without setting another
pin (say power_on), or if any transient glitches on the line has no
functional impact, I might go with no pull configuration.
It all depends on the schematics and peripherals involved w.r.t how
you'd optimally select the configuration.
--
Regards,
Nishanth Menon
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
