On 25/10/13 14:14, Nishanth Menon wrote:
> lcd2_pins: pinmux_lcd2_pins {
> + pinctrl-single,pins = <
> + 0x20 (PIN_OUTPUT_PULLDOWN | MUX_MODE3) /* gpio_40 */
> + 0x46 (PIN_OUTPUT_PULLUP | MUX_MODE3) /* gpio_59 */
> + 0x56 (PIN_OUTPUT_PULLDOWN | MUX_MODE3) /* gpio_104 */
> + >;
>
> 3 pins are driven around 300uA at boot, even with display OFF -> which
> means wasted current that could have been optimized by hooking the pin
> to the dts node corresponding to the device and used by the driver
> appropriately.
One more clarification question.
The gpio 40 is used to enable powers for the picodlp. Shouldn't that one
have a pinctrl pull-down in any case? If it's left floating, and the
driver is not compiled in or doesn't start, the powers could get enabled
depending on sunspot, right?
And I guess the same goes for all gpios used to enable something.
Tomi
Attachment:
signature.asc
Description: OpenPGP digital signature
