Re: [PATCH V4] ARM: OMAP5/DRA7: realtime_counter: Configure CNTFRQ register

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



* Sricharan R <r.sricharan@xxxxxx> [131003 03:27]:
> On Wednesday 18 September 2013 09:32 PM, Sricharan R wrote:
> > --- a/arch/arm/boot/dts/omap5.dtsi
> > +++ b/arch/arm/boot/dts/omap5.dtsi
> > @@ -52,7 +52,6 @@
> >  			     <GIC_PPI 14 (GIC_CPU_MASK_RAW(3) | IRQ_TYPE_LEVEL_LOW)>,
> >  			     <GIC_PPI 11 (GIC_CPU_MASK_RAW(3) | IRQ_TYPE_LEVEL_LOW)>,
> >  			     <GIC_PPI 10 (GIC_CPU_MASK_RAW(3) | IRQ_TYPE_LEVEL_LOW)>;
> > -		clock-frequency = <6144000>;
> >  	};
> >  
> >  	gic: interrupt-controller@48211000 {

Can the above be done later on in a separate clean-up patch?
If so I can drop that part as that removes a dependency to the
.dts patches queued by Benoit.

> > --- a/arch/arm/mach-omap2/omap-smp.c
> > +++ b/arch/arm/mach-omap2/omap-smp.c
> > @@ -41,6 +41,8 @@
> >  
> >  u16 pm44xx_errata;
> >  
> > +extern unsigned long arch_timer_freq;
> > +
> >  /* SCU base address */
> >  static void __iomem *scu_base;
> >  

No externs in *.c files please, checkpatch.pl and sparse should warn
about this.

>  Are you planning to pull this patch and the below $subject patch as well? They are
>  acked and tested.
> 
>  ARM: DRA7: realtime_counter: Add ratio registers for 20MHZ sys-clk frequency
> 
>   http://www.spinics.net/lists/linux-omap/msg97281.html

The 20MHz patch I've applied, just noticed the above things
when was about to apply this.

Regards,

Tony
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html




[Index of Archives]     [Linux Arm (vger)]     [ARM Kernel]     [ARM MSM]     [Linux Tegra]     [Linux WPAN Networking]     [Linux Wireless Networking]     [Maemo Users]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite Trails]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux