* Grygorii Strashko <grygorii.strashko@xxxxxx> [130717 04:49]: > Add dynamic "active"/"idle" pin states for uart3/4 which will be applied > when uart3/4 state is switched from active to idle and back by Runtime > PM or during system suspend. This is good for testing code, but should not be merged because omap4 has the iopad wake-ups available for uarts. So those can be always enabled. > --- a/arch/arm/boot/dts/omap4-sdp.dts > +++ b/arch/arm/boot/dts/omap4-sdp.dts > @@ -181,18 +181,40 @@ > pinctrl-single,pins = < > 0x100 (PIN_INPUT_PULLUP | MUX_MODE0) /* uart3_cts_rctx.uart3_cts_rctx */ > 0x102 (PIN_OUTPUT | MUX_MODE0) /* uart3_rts_sd.uart3_rts_sd */ > - 0x104 (PIN_INPUT | MUX_MODE0) /* uart3_rx_irrx.uart3_rx_irrx */ > 0x106 (PIN_OUTPUT | MUX_MODE0) /* uart3_tx_irtx.uart3_tx_irtx */ > >; > }; This just need to become: pinctrl-single,pins = < ... 0x104 (WAKEUP_EN | PIN_INPUT_MUX_MODE0) /* uart3_rx_irrx.uart3_rx_irrx */ ... >; interrupts = <GIC_SPI 74 IRQ_TYPE_LEVEL_HIGH>; }; And so on. For am33xx you need to remux things to GPIO for the wake-up events, so you should maybe test on that instead. Regards, Tony -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
