* Balaji T K <balajitk@xxxxxx> [130606 12:20]:
> handle vcc and vcc_aux independently
>
> Signed-off-by: Balaji T K <balajitk@xxxxxx>
> ---
> drivers/mmc/host/omap_hsmmc.c | 9 +++++----
> 1 files changed, 5 insertions(+), 4 deletions(-)
>
> diff --git a/drivers/mmc/host/omap_hsmmc.c b/drivers/mmc/host/omap_hsmmc.c
> index 1865321..bda1a42 100644
> --- a/drivers/mmc/host/omap_hsmmc.c
> +++ b/drivers/mmc/host/omap_hsmmc.c
> @@ -253,7 +253,7 @@ static int omap_hsmmc_set_power(struct device *dev, int slot, int power_on,
> * If we don't see a Vcc regulator, assume it's a fixed
> * voltage always-on regulator.
> */
> - if (!host->vcc)
> + if (!host->vcc && !host->vcc_aux)
> return 0;
> /*
> * With DT, never turn OFF the regulator for MMC1. This is because
Doesn't the above change break MMC for most boards that only pass
one regulator and no aux regulator?
Regards,
Tony
> @@ -280,11 +280,12 @@ static int omap_hsmmc_set_power(struct device *dev, int slot, int power_on,
> * chips/cards need an interface voltage rail too.
> */
> if (power_on) {
> - ret = mmc_regulator_set_ocr(host->mmc, host->vcc, vdd);
> + if (host->vcc)
> + ret = mmc_regulator_set_ocr(host->mmc, host->vcc, vdd);
> /* Enable interface voltage rail, if needed */
> if (ret == 0 && host->vcc_aux) {
> ret = regulator_enable(host->vcc_aux);
> - if (ret < 0)
> + if (ret < 0 && host->vcc)
> ret = mmc_regulator_set_ocr(host->mmc,
> host->vcc, 0);
> }
> @@ -292,7 +293,7 @@ static int omap_hsmmc_set_power(struct device *dev, int slot, int power_on,
> /* Shut down the rail */
> if (host->vcc_aux)
> ret = regulator_disable(host->vcc_aux);
> - if (!ret) {
> + if (host->vcc) {
> /* Then proceed to shut down the local regulator */
> ret = mmc_regulator_set_ocr(host->mmc,
> host->vcc, 0);
> --
> 1.7.5.4
>
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
