OMAP4 panda board specific device tree node is included.
In OMAP4 panda board, the port 1 is used in ULPI PHY mode.
The port 1 is connected to a on board hub with ethernet
interface.
TODO:
The clock bindings are not yet avilable for OMAP4.
hence , USB hub specific clocks are exported as device tree string
paramters.
Will be changed to use the clock bindings later
Signed-off-by: Keshava Munegowda <keshava_mgowda@xxxxxx>
---
arch/arm/boot/dts/omap4-panda.dts | 33 +++++++++++++++++++++++++++++++++
1 file changed, 33 insertions(+)
diff --git a/arch/arm/boot/dts/omap4-panda.dts b/arch/arm/boot/dts/omap4-panda.dts
index e8f927c..dad0df6 100644
--- a/arch/arm/boot/dts/omap4-panda.dts
+++ b/arch/arm/boot/dts/omap4-panda.dts
@@ -184,3 +184,36 @@
&dmic {
status = "disabled";
};
+
+&usbhs {
+ /*
+ * Maximum fill 3 port info.
+ * port configured can be any one of the following values
+ * OMAP_USBHS_PORT_MODE_UNUSED = 0,
+ * OMAP_EHCI_PORT_MODE_PHY = 1,
+ * OMAP_EHCI_PORT_MODE_TLL = 2,
+ * OMAP_EHCI_PORT_MODE_HSIC = 3,
+ * OMAP_OHCI_PORT_MODE_PHY_6PIN_DATSE0 = 4,
+ * OMAP_OHCI_PORT_MODE_PHY_6PIN_DPDM = 5,
+ * OMAP_OHCI_PORT_MODE_PHY_3PIN_DATSE0 = 6,
+ * OMAP_OHCI_PORT_MODE_PHY_4PIN_DPDM = 7,
+ * OMAP_OHCI_PORT_MODE_TLL_6PIN_DATSE0 = 8,
+ * OMAP_OHCI_PORT_MODE_TLL_6PIN_DPDM = 9,
+ * OMAP_OHCI_PORT_MODE_TLL_3PIN_DATSE0 = 10,
+ * OMAP_OHCI_PORT_MODE_TLL_4PIN_DPDM = 11,
+ * OMAP_OHCI_PORT_MODE_TLL_2PIN_DATSE0 = 12,
+ * OMAP_OHCI_PORT_MODE_TLL_2PIN_DPDM = 13,
+ */
+ port-0 = <1>;
+ port-1 = <0>;
+ port-2 = <0>;
+
+ /*
+ * In some boards, the controller is always connected to hub
+ * the pandboard always has the hub connect to port0 of usbhs controller
+ */
+ hub-power-gpio = <&gpio1 1 0>;
+ hub-reset-gpio = <&gpio2 30 0>; /* gpio 62 */
+ hub-clk = "auxclk3_ck";
+ hub-clkrate = <19200000>;
+};
--
1.7.9.5
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
