The SCD (special character detect) bit enables comparisons with XOFF2, which we do not program. As the XOFF2 character remains unprogrammed, there's little point enabling this feature along with its associated interrupt. Remove this, and ensure that the SCD bit is cleared. Signed-off-by: Russell King <rmk+kernel@xxxxxxxxxxxxxxxx> --- drivers/tty/serial/omap-serial.c | 8 ++------ 1 files changed, 2 insertions(+), 6 deletions(-) diff --git a/drivers/tty/serial/omap-serial.c b/drivers/tty/serial/omap-serial.c index 7c313c2..71db4e6 100644 --- a/drivers/tty/serial/omap-serial.c +++ b/drivers/tty/serial/omap-serial.c @@ -704,13 +704,8 @@ serial_omap_configure_xonxoff serial_out(up, UART_MCR, up->mcr | UART_MCR_TCRTLR); serial_out(up, UART_LCR, UART_LCR_CONF_MODE_B); serial_out(up, UART_TI752_TCR, OMAP_UART_TCR_TRIG); - /* Enable special char function UARTi.EFR_REG[5] and - * load the new software flow control mode IXON or IXOFF - * and restore the UARTi.EFR_REG[4] ENHANCED_EN value. - */ - serial_out(up, UART_EFR, up->efr | UART_EFR_SCD); + serial_out(up, UART_EFR, up->efr); serial_out(up, UART_LCR, UART_LCR_CONF_MODE_A); - serial_out(up, UART_MCR, up->mcr & ~UART_MCR_TCRTLR); serial_out(up, UART_LCR, up->lcr); } @@ -843,6 +838,7 @@ serial_omap_set_termios(struct uart_port *port, struct ktermios *termios, serial_out(up, UART_LCR, UART_LCR_CONF_MODE_B); up->efr = serial_in(up, UART_EFR); + up->efr &= ~UART_EFR_SCD; serial_out(up, UART_EFR, up->efr | UART_EFR_ECB); serial_out(up, UART_LCR, UART_LCR_CONF_MODE_A); -- 1.7.4.4 -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
